Quantum Data 700 Series manual Service and Support Contacts

Page 26

Service and Support Contacts

To contact Technical Support, see http://www.quantumdata.com/contact/support.asp.

For factory-authorized service centers, see http://www.quantumdata.com/contact/locations.asp.

Model 700, 701 Quick Start Guide 68-00198-D (12-Dec-2004)

Copyright © 2003 by Quantum Data, Inc. All rights reserved.

The information contained in this document is provided for use by our customers and may not be incorporated into other products or publications without the expressed written consent of Quantum Data. Information furnished by Quantum Data is believed to be accurate and reliable. However, no responsibility is assumed by Quantum Data for its use.

Quantum Data reserves the right to make changes at any time and without notice to its products to improve performance, reliability, manufacturing methods, and (or) marketability.

Documentation based on firmware version 1.6.0.

Declaration of Conformity

Manufacturer’s Name: Quantum Data, Inc.

Manufacturer’s Address: 2111 Big Timber Rd.

Elgin, IL 60123-1100; USA

The manufacturer hereby declares that the product:

Product Name: Video Test Generator

Model Numbers: 700, 701

conforms to the following standards or other normative documents:

CENLEC EN55022, RF Emissions: 1998

EN55022 Conducted Emissions, AC Mains (0.15-30 MHz) Class A

EN55022 RF Radiated Emissions (30-1000 MHz) Class A

CENLEC EN61326, Electrical Equipment for measurement, control and laboratory use - EMC Requirements: 1997

Complies with Sections Listed Above

89/336/EEC EMC Directive

Supplementary Information

The external power supply and power cord supplied with the unit are required for electromagnetic compatibility.

Use of premium quality shielded cables is required for electromagnetic compatibility.

When and Where Issued

Marks of Compliance

07-September-2001 Romeoville, IL; USA

26

Image 26
Contents Page Contents Getting Started Using AC PowerUsing Battery Power Computer Interfaces DVI-IFunction Buttons User InterfaceLCD Display Selecting Formats Viewing Formats by Signal TypeSelecting Formats Reloading Standard FormatsGating Outputs Selecting ImagesSelecting Images Options Menu Setting Power Save PreferencesSetting Power Save Preference Calibrating Equipment Needed for CalibrationCalibrating Outputs Locking Calibration Settings Adjusting Horizontal Scanning FrequencyDetecting Formats Supported by a Monitor Learn MonitorRunning Test Sequence Manually Using Test SequencesTest Menu Running Test Sequence in Burn-In Mode Creating Test Sequence for DDC DisplaysTesting Hdcp Interfaces Using Generator with CS-1 ProbeTesting Audio Special TestsGenerating Pseudo Random Noise VGM Quick Tour Using Video Generator ManagerAbout VGM Creating Video Formats Editing Video FormatsModifying Test Sequence Editing the Test SequenceGrid Pattern DescriptionsFlatWht/R,G,B RevGridWindow RasterCutoff FocusDot12 RegulateChecker SMPTEBarBurst RampPulseBar Updating Firmware Updating FirmwareSpecifications Video FormatsService and Support Contacts