1.If the detector is on, turn MODE to OFF.
Note: When you turn the mode switch to OFF, the LOW BATT indicator flashes once.
2.Press the right battery compartment cover’s tab and slide the cover off in the direction of the arrow.
3.Place a
4.Replace the right battery compartment cover.
5.Press the left battery compartment cover’s tab and slide the cover off in the direction of the arrow.
6.Place a
7.Replace the left battery compartment cover.
Warning: Dispose of old batteries promptly and properly. Do not burn or bury them.
Caution: If you do not plan to use the detec- tor for a week or more, remove the batteries. Batteries can leak chemicals that can de- stroy electronic parts.
Notes:
•For better life, exchange the two batter- ies periodically.
•You can extend battery life by using headphones, which require less power than the
If the LOW BATT indicator lights during nor- mal use or the detector does not function properly, replace the batteries. If it still does not function properly, you might need to re- set the detector.
USING HEADPHONES
You can connect a pair of stereo head- phones (not supplied) to the detector so you can listen to it privately. Using headphones also saves battery power and makes it easier to identify subtle changes in the sounds you hear, for better detection results. Your local RadioShack store has a wide selection of headphones.
To connect head- phones to the de- tector, insert the
headphones’ | 1/8- |
| |
inch plug into | the | PHONE | |
PHONE jack on the | |||
Jack | |||
side of the control | |||
| |||
housing. |
|
| |
The detector’s | in- |
| |
ternal speaker disconnects when you con- nect headphones.
Listening Safely
To protect your hearing, follow these guide- lines when you use headphones.
•Set the volume to the lowest setting before you begin listening. After you begin listening, adjust the volume to a comfortable level.
Preparation | 5 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|