RedMax SRTZ2460F manual HOW to MIX Fuel Recommended Mixing Ratio Gasoline 50 OIL, Fueling the Unit

Page 11

SRTZ2460F

7. Fuel

test standard has been discontinued by API in 1995 and it no longer exists.

IMPORTANT

Gasoline/Oil mixture Storage Recommendations

Store your gasoline or gasoline/oil mixture in a cool dry area in a tightly sealed approved container to limit the entry of moisture and additional air (oxygen). Moisture and air cause the development of varnish and gum, making the fuel stale. Stored gasoline and gasoline/oil mixture ages and loses its octane rating and volatility. Do not mix more gasoline/oil than you intend to use in 30 days, and 60 days when fuel stabilizer is added. RedMax Air-Cooled "Max Life" Synthetic blend Premium two-stroke engine oil "Contains fuel stabilizer" and will automatically extend your gasoline/oil mixture life up to 60 days.

HOW TO MIX FUEL

RECOMMENDED MIXING RATIO GASOLINE 50 : OIL 1

(when using RedMax Air-Cooled "Max Life")

50:1 MIXING CHART

GASOLINE

gal.

1

2

3

4

5

 

 

 

 

 

 

 

2-CYCLE OIL

fl.oz

2.6

5.2

7.8

10.4

13

 

 

 

 

 

 

 

 

 

 

 

 

 

 

GASOLINE

liter

1

2

3

4

5

 

 

 

 

 

 

 

2-CYCLE OIL

ml

20

40

60

80

100

 

 

 

 

 

 

 

WARNING

1.Select flat and bare ground for fueling.

2.Move at least 10 feet (3 meters) away from the fueling point before starting the engine.

3.Stop the engine before refueling the unit. At that time, be sure to sufficiently agitate the mixed gasoline in the container.

FOR YOUR ENGINE LIFE, AVOID

1.FUEL WITH NO OIL (RAW GASOLINE) – It will cause severe damage to the internal engine parts very quickly.

2.GASOHOL – It can cause deterioration of rubber and/or plastic parts and disruption of engine lubrication.

3.OIL FOR 4-CYCLE ENGINE USE – It can cause spark plug fouling, exhaust port blocking, or piston ring seizure.

4.Mixed fuels which have been left unused for a period of one month or more may clog the carburetor and result in the engine failing to operate properly.

5.In the case of storing the product for a long period of time, clean the fuel tank after rendering it empty. Next, Start the engine and run the carburetor dry residual fuel.

6.In the case of scrapping the used mixed oil container, scrap it only at an authorized depository site.

NOTE

As for details of quality assurance, read the description in the section Limited Warranty carefully. Moreover, normal wear and change in product with no functional influence are not covered by the warranty. Also, be careful that, if the usage in the instruction manual is not observed as to the mixed gasoline, type of oil or fuel to be used. described therein, it may not be covered by the warranty.

WARNING

• Pay attention to agitation.

1.Measure out the quantities of gasoline and oil to be mixed.

2.Put some of the gasoline into a clean, approved fuel container.

3.Pour in all of the oil and agitate well for 10seconds.

4.Pour in the rest of gasoline and agitate again for at least one minute. As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary. Be careful that, if the agitation is insufficient, there is an increased danger of early piston seizure due to abnormally lean mixture.

5.Place a clear indication on the outside of the container to avoid mixing up with gasoline or other containers that dont contain oil.

6.Indicate the contents on outside of container for easy identification.

FUELING THE UNIT

1.Untwist and remove the fuel cap. Rest the cap on a clean surface.

2.Put fuel into the fuel tank to 80% of the full capacity.

3.Fasten the fuel cap securely and wipe up any fuel spillage around the unit.

US-10

Image 11
Contents SRTZ2460F SRTZ2460F Contents Parts location SpecificationsManufactured Symbols on the machineWear head, eye and ear protection Emission ControlFor safe operation Starting the engine Using the productFuel safety Before useDisposal MaintenanceStorage Set up Gasoline Requirements WarrantyFuel FuelFueling the Unit HOW to MIX Fuel Recommended Mixing Ratio Gasoline 50 OILFor Your Engine LIFE, Avoid Operation Following instructions when using your trimmer Maintenance MA6 Replacement Plug is a NGK CMR7HMA3 AIR Filter MufflerMA8 Procedures to be Performed After Every 100 Hours of USEStorage DisposalCheck Probable Causes Action Troubleshooting guideCase 1. Starting failure What is Covered Manufacturers Warranty CoverageOwners Warranty Responsibilities Warranty Commencement DateWhere to GET Warranty Service Emission Warranty Parts ListWhat is not Covered HOW to File a Claim