9. Maintenance
engine cover shown in (MA7) in order to be able to view the upper part of the cylinder.
SRTZ2460F
10. Storage
• Aged fuel is one of major causes of |
engine starting failure. Before storing |
the unit, empty the fuel tank and run |
the engine until it uses all the fuel left in |
MA7 (1)
(2)
MA8
IMPORTANT
•If waste gets stuck and causes blockage around the intake air cooling vent or between the cylinder fins, it may cause the engine to overheat, and that in turn may cause mechanical failure on the part of the brushcutter. (MA7)
(1)cylinder
(2)intake air cooling vent (back)
■PROCEDURES TO BE PERFORMED AFTER EVERY 100 HOURS OF USE
1.Remove the muffler, insert a screwdriver into the vent, and wipe away any carbon buildup. Wipe away any carbon buildup on the muffler exhaust vent and cylinder exhaust port at the same time.
2.Tighten all screws, bolts, and fittings.
3.Check to see if any oil or grease has worked its way in between the clutch lining and drum, and if it has wipe it away using
the fuel line and the carburetor. Store |
the unit indoor taking necessary |
measures for rust prevention. |
11. Disposal
•When disposing your machine, fuel or oil for the machine, be sure to allow your local regulations.
U S