RedMax SRTZ2460F manual Set up

Page 9

SRTZ2460F

6. Set up

MOUNTING ENGINE (SE1)

BALANCE UNIT

SE1

1.Push the driveshaft housing toward the clutch housing and rotate it by hand to check that the driveshaft is engaged with the gears.

2.Insert the driveshaft housing into the clutch housing until it bottoms, and align the positioning holes on the clutch housing and the shaft tube and install the screw. When difficult to engage, twist the engine slightly.

3.Fasten the clamp securely with two screws.

1.Put on strap and attach unit to strap.

2.Depending on the working posture, slide clamp up or down until unit balances and the strap fits your body.

IMPORTANT

Tighten the screws gradually by turns.

SE2

CONNECTING THROTTLE WIRE

1. Remove the air cleaner cover.

2. Connect the end of the throttle wire to the joint on the top of the carburetor. (SE2)

CONNECTING SWITCH WIRES

Connect the switch wires between the engine and the main unit. Pair the wires of the same color.

SE3

(1)

SE4

 

 

(1)

(3)

(2)

 

(4)

(5)

 

INSTALLING HANDLE

Mount the handle to the shaft tube and clamp it at a location that is comfortable to you. (SE3)

(1) About 19 inches (48cm)

ATTACHING THE TRIMMING MECHANISM (SE4)

1.Remove the screw screwed into the end of the trimming mechanism.

2.Insert the end of the trimming mechanism into the shaft tube.

3.Line up the hole on the end of the trimming mechanism into which the screw is to be inserted with the hole on the shaft tube, and screw the screw firmly in.

4.Using a wrench, screw in the bolt provided to fix the trimming mechanism into place.

(1)Shaft tube

(2)Trimming mechanishm

(3)Screw hole

(4)Bolt

(5)Fastening bolt

US-8

Image 9
Contents SRTZ2460F SRTZ2460F Contents Parts location SpecificationsWear head, eye and ear protection Symbols on the machineEmission Control ManufacturedFor safe operation Fuel safety Using the productBefore use Starting the engineMaintenance StorageDisposal Set up Fuel WarrantyFuel Gasoline RequirementsHOW to MIX Fuel Recommended Mixing Ratio Gasoline 50 OIL For Your Engine LIFE, AvoidFueling the Unit Operation Following instructions when using your trimmer Maintenance MA3 AIR Filter Replacement Plug is a NGK CMR7HMuffler MA6Storage Procedures to be Performed After Every 100 Hours of USEDisposal MA8Troubleshooting guide Case 1. Starting failureCheck Probable Causes Action Owners Warranty Responsibilities Manufacturers Warranty CoverageWarranty Commencement Date What is CoveredWhat is not Covered Emission Warranty Parts ListHOW to File a Claim Where to GET Warranty Service