RedMax BT250 manual Fueling the Unit, For Your Engine LIFE, Avoid

Page 15

7. Fuel

again for at least one minute. As some oils may be difficult to agitate depending on oil ingredients, sufficient agitation is necessary for the engine to last long. Be careful that, if the agitation is insufficient, there is an increased danger of early piston seizing due to abnormally lean mixture.

5.Put a clear indication on the outside of the container to avoid mixing up with gasoline or other containers.

6.Indicate the contents on outside of container for easy identification.

FUELING THE UNIT

1.Untwist and remove the fuel cap. Rest the cap on a dustless place.

2.Put fuel into the fuel tank to 80% of the full capacity.

3.Fasten the fuel cap securely and wipe up any fuel spillage around the unit.

WARNING

1.Select bare ground for fueling.

2.Move at least 10feet (3meters) away from the fueling point before starting the engine.

3.Stop the engine before refueling the unit. At that time, be sure to sufficiently agitate the mixed gasoline in the container.

FOR YOUR ENGINE LIFE, AVOID;

1.FUEL WITH NO OIL(RAW GASOLINE) – It will cause severe damage to the internal engine parts very quickly.

2.GASOHOL – It can cause deterioration of rubber and/or plastic parts and disruption of engine lubrication.

3.OIL FOR 4-CYCLE ENGINE USE – It can cause spark plug fouling, exhaust port blocking, or piston ring sticking.

4.Mixed fuels which have been left unused for a period of one month or more may clog the carburetor and result in the engine failing to operate properly.

5.In the case of storing the product for a

long period of time, clean the fuel tank after rendering it empty. Next, activate the engine and empty the carburetor of the composite fuel.

6.In the case of scrapping the used mixed oil container, scrap it only at an authorized repository site.

NOTE

As lot details of quality assurance, read the description in the section Limited Warranty carefully. Moreover, normal wear and change in product with no functional influence are not covered by the warranty. Also, be careful that, if the usage in the instruction manual is not observed as to the mixed gasoline, etc. described therein, it may not be covered by the warranty.

15

Image 15
Contents BT250 Page Contents Safety FirstSpecifications Parts location 4   5  Symbols on the machine Fammille DE Moteur 5HCPS.025ADEM 6   7  For safe operationWorking Condition Working Circumstance 8  Working PlanBefore Starting the Engine Starting the Engine 9   10  Using the Product 11  MaintenanceIf Someone Comes Handling Fuel 12  TransportationInstalling Cutting Head SE3 Set upSE1 SE2 SE3 Installing Handle SE1 Installing Debris Guard SE2Recommended Mixing Ratio Gasoline 50OIL HOW to MIX FuelFuel  14 For Your Engine LIFE, Avoid Fueling the UnitStarting Engine OperationOP1 OP2 OP3 OP4  16 Trimming Grass and Weeds Adjusting Idling Speed OP5OP5 OP6 Stopping Engine Line Head Usage 18  Adjusting the Line LengthMaintenance Refilling Trimming Line 19   20  Spark Plug MA1 MA2 MA3 MA4AIR Filter Fuel FilterSpark Arrester MA5 22  MufflerProcedures to be Performed After Every 100 Hours of USE MA6 MA7 23   24  Troubleshooting guideStorage Check Probable Causes Action 25  Parts list 26  Drive Unit BT250 S/N 40400101 and up 27  BT25-50910 Housing Assy 28  Engine Unit BT250 S/N KU40001 and upElement  29 Limited Warranty RedMax Garantie limitée