Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool off and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and
Lubrication
1.Before each use, inspect the general condition of the Circular Saw. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use.
Do not use damaged equipment.
2.Before remounting the Saw Blade, remove all sawdust that has accumulated around the safety guard.
3.Regularly inspect and tighten all mounting screws and knobs.
4.Keep Saw Blade clean and sharp. Sharp blades minimize stalling and kickback.
5.Keep guards in good working order.
6.Keep motor air vent clean of dust and debris. Vacuum periodically.
7.If the tool is not operating normally, making unusual noises, or appears defective, stop using it immediately and get it repaired.
8.Clean tool with a damp cloth and light detergent. Do not use solvents as they can damage and crack the plastic parts.
9.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
Replacing the Carbon Brushes
1.Unscrew the Carbon Brush Covers (55).
2.Pull out the Carbon Brush (54) from each side of the motor and examine them.
If they are worn more than half way down, replace them. It could be that they are simply dirty. They can be cleaned using an ink eraser.
3.Replace the Carbon Brushes (54) and Covers (55).
SKU 94245 | For technical questions, please call | Page 14 |