WHAT IS WHAT?
| 14 |
|
|
|
|
|
| 15 | 12 |
|
|
|
| |
|
|
|
| 13 |
| 1 | 2 |
|
|
|
| 8 |
| |
|
|
|
| |
|
|
| 9 |
|
| 6 |
|
| 10 |
| 5 |
|
|
|
|
|
| 4 |
|
| 3 |
| 7 |
|
|
|
|
| |
WHAT IS WHAT? |
|
|
| |
1. | Throttle trigger | 9. | Upper blower tube |
|
2. | STOP switch | 10. | Lower blower tube |
|
3. | Primer button | 11. |
| |
4. | Choke lever | 12. | Elbow tube |
|
5. | Fuel cap | 13. | Vacuum bag |
|
6. | Starter rope | 14. | Upper vacuum tube |
|
7. | Vacuum handle | 15. | Lower vacuum tube |
|
8. | Spark plug | 16. | Instruction manual |
|
11
16
ASSEMBLY
CARTON CONTENTS
Check carton contents against the following list.
SBlower
SUpper blower tube S Lower blower tube S High velocity nozzle S Elbow tube
S Vacuum bag
S Upper vacuum tube S Lower vacuum tube
S Screw for vacuum tube assembly NOTE: It is normal for the fuel filter to rattle in the empty fuel tank.
ASSEMBLY
WARNING: Stop engine and be sure the impeller blades have stopped turning be- fore opening the vacuum inlet door or at- tempting to insert or remove the vacuum or blower tubes. The rotating blades can cause serious injury. Always disconnect the spark plug before performing maintenance or ac- cessing movable parts.
WARNING: If received assembled, repeat all steps to ensure your unit is properly
assembled and all fasteners are secure. Fol- low all safety information in the manual and on the unit.
DA standard screwdriver is required for as- sembly.
BLOWER ASSEMBLY
BLOWER TUBE ASSEMBLY
1.Align the rib on the upper blower tube with the groove in the blower outlet; slide the tube into place.
NOTE: The tube clamp bolt must be loose enough to allow blower tube to be inserted in blower outlet. Loosen the bolt by turning coun- terclockwise (do not remove nuts).
Blower Outlet
Groove Rib
2.Secure the tube by turning the bolt clock- wise.
3.Align the slots on the lower blower tube with the tabs on the upper blower tube.