McCulloch MAC GBV 325 Replace Spark Plug, Replace Fuel Filter, Check Muffler Mounting Screws

Page 9

A dirty air filter decreases engine perform- ance and increases fuel consumption and harmful emissions. Always clean after every 5 hours of operation or yearly, whichever comes first.

1.Clean the cover and the area around it to keep debris from falling into the carburetor chamber when the cover is removed.

NOTE: Move choke lever to RUN position before opening air filter cover.

2.Remove parts as illustrated. NOTE: Do not clean filter in gasoline or other flammable solvent. Doing so can create a fire hazard or produce harmful evaporative emissions.

3.Wash the filter in soap and water.

4.Allow filter to dry.

5.Apply a few drops of oil to the filter; squeeze filter to distribute oil.

6.Replace parts.

REPLACE SPARK PLUG

Replace spark plug each year to ensure the engine starts easier and runs better. Set spark plug gap at 0.6 mm. Ignition timing is fixed, nonadjustable.

1.Twist, then pull off spark plug boot.

2.Remove spark plug from cylinder and dis- card.

3.Replace with Champion RCJ-6Y spark plug and tighten securely with a 19 mm socket wrench.

4.Reinstall the spark plug boot.

REPLACE FUEL FILTER

To replace fuel filter, drain unit by running it dry of fuel, then remove fuel cap/retainer assembly from tank. Pull filter from tank and remove it from fuel line. Install new fuel filter on fuel line; reinstall parts.

Fuel Filter

Fuel Line

CHECK MUFFLER MOUNTING SCREWS

Once each year, ensure muffler mounting screws are secure and tightened properly to prevent damage.

Muffler

Mounting

Screw

CARBURETOR ADJUSTMENTS

The carburetor has been carefully set at the factory. Adjustments may be necessary if you notice any of the following conditions:

S Engine will not idle when the throttle is re- leased.

Idle Speed Adjustment

Allow engine to idle. Adjust speed until engine runs without stalling (idle speed too slow).

S Turn idle speed screw clockwise to in- crease engine speed if engine stalls or dies.

STurn idle speed screw counterclockwise to decrease engine speed.

Idle Speed Screw

Air

Filter

Cover

If you require further assistance or are unsure about performing this procedure, contact an authorized service dealer.

-- 9 --

Image 9
Contents Betriebsanweisung Manuel D’INSTRUCTIONSManual DE Instrucciones Libretto D’ISTRUZIONISafety Rules KEY to SymbolsKnow Your Unit Plan AheadOperate Your Unit Safely Fuel SafetyMaintain Your Unit Properly Hol, drugs, or medicationAssembly What is WHAT?Carton Contents AssemblyVacuum BAG Assembly HIGH-SPEED Nozzle AssemblyVacuum Tube Assembly OutletHOW to Convert Unit from Vacuum USE to Blower USE Shoulder Strap AdjustmentLower Upper Operation Maintenance Replace Spark Plug Carburetor AdjustmentsReplace Fuel Filter Check Muffler Mounting ScrewsInternal Engine Troubleshooting Table Cause RemedyOther External SurfacesCOUNCIL’S Directives Declaration of ConformityEngine WeightIgnition System Fuel and Librication System