Korg SP-250 manual Turning the instrument on, Turning the internal speakers on or off

Turning the instrument on

Insert the DC plug of the supplied AC adapter into the DC inlet of the SP-250, then connect the AC plug to a wall socket. You can use the dedicated hook to fix the power cable to the piano’s back panel, as shown in the following illustration:

After having connected the power cable, press the POWER switch. When the instru- ment is turned on, the LEDs on the control panel will light up. To turn the instru- ment off, press the POWER switch again.

Note: When the instrument is turned off, all parameters are reset.

Turning the internal speakers on or off

Whether you prefer listening to the internal speakers or to an external amplification system, you can turn the internal speakers on or off. Insert a jack (or connect a head- phone set) to one of the PHONES connectors to turn the speakers off.

Adjusting the volume

Move the MASTER VOLUME slider towards the right to increase the volume; towards the left to decrease the volume. The maximum is “10”; the minimum (silence) is “0”. This control adjusts the output level of the headphones, the internal speakers and of the OUTPUTs.

Note: It is always better to start with a low volume and then increase gradually.

Listening to the Demo

The SP-250 contains 30 pre-recorded demo songs. Listen to them to experience the rich sound and expressive potential of this instrument.

Listen to all songs at once. You can listen to all demo songs with a single com- mand.

Before you begin 13