1Hold down the REVERB or CHORUS button, and press either the PIANO 1/L, PIANO 2/M, or E.PIANO1/H sound selection button to select the reverb or chorus depth.
Button | Reverb depth | Chorus depth |
|
|
|
PIANO 1/L | Light reverb | Light chorus |
|
|
|
PIANO 2/M | Normal reverb | Normal chorus |
|
|
|
E.PIANO 1/H | Deep reverb | Deep chorus |
|
|
|
2To check the currently selected reverb or chorus depth, hold down the REVERB or CHORUS button, and look at which of the above LEDs is turned on.
3To turn the reverb or chorus off, press the REVERB or CHORUS button. The LED on the button will turn off.
The damper pedal
The supplied pedal can be used as a damper pedal. You can also use the half- pedalling, with a gradual resonance effect depending on the depth of the pedal pres- sure.
In Layer mode, you can select the sound(s) to apply the pedal to.
Note: When the instrument is turned on, the pedal settings are reset. To save these settings, save them using the Data Dump function (see “MIDI Data Dump” on page 31).
1Hold the TRANSPOSE/FUNCTION button, and press the damper pedal. Each time you press the pedal, the LED on the sound selection button(s) where the damper pedal is active will light.
2When the pedal is assigned to the desired sound(s), release the TRANSPOSE/ FUNCTION button.
The metronome
The
Starting and stopping the metronome. Press the METRONOME button to make the metronome start or stop. When turning on, the metronome is set according to the slider position, but you can adjust it with the procedure described below. After having listened to the demo, the tempo will be that of the last demo that had been listened to.
18 | Chapter 3 |
