Makita BLM430, LM430D dimensions Repair, Handle section, Disassembling

Upper pipe complete

P 2/ 8

Repair

CAUTION: Repair the machine in accordance with “Instruction manual” or “Safety instructions”.

[1] NECESSARY REPAIRING TOOLS

Code No.	Description	Use for
1R285	Round bar for Arbor 11-50	removing Plane bearing 10 from Front/ Rear wheels

[2]ASSEMBLY/ DISASSEMBLY

[2]-1. Handle section

DISASSEMBLING

(1)Lift and remove Rear bag section from Deck. (Fig. 1)

While holding Handle section (Lower pipe, Upper pipe complete, etc.), loosen two M6 Thumb screws. (Fig. 1)

Handle section is removed. (Fig. 2)

(2)Remove two Holders 9-19 from Lower pipe.

Remove two M6 Thumb nuts and M6x50 two Cup hex square neck bolts, and then separate Upper pipe complete from Lower pipe. (Fig. 3)

Lower pipe can be replaced.

(3)Loosen 4x18 Tapping screw, then remove Switch lever case and Switch lever case cover. (Fig. 4)

(4)Loosen four 4x18 Tapping screws, then remove Switch box cover complete

and Switch box. (Fig. 5)	Fig. 2
(5) Remove Tension spring 9, and then separate Lever
and M4x20 Pan head screw with WR (spring washer
and Flat washer) from Switch box and Switch lever.

Upper pipe complete and Lever can be replaced. (Fig. 6)

Fig. 1

Upper pipe complete

Lower pipe

M8x35 Thumb screw (2 pcs.)

Deck

Rear bag complete

Lower pipe	M8x35 Thumb
	screw

	Holder 9-19 (2 pcs.)	M8x35
		Thumb screw
Fig. 3	Fig. 4
	Switch lever
		Switch lever case
Upper pipe complete	Lower pipe
	M6 Thumb nut
	(2 pcs.)	4x18 Tapping
		screw
		Switch lever case cover
M6x50 Cup hex square neck bolt	Upper pipe complete
	Holder 9-19 (2 pcs.)
Fig. 5	Fig. 6
Switch lever	Switch box
Switch box cover complete	Tension spring 9
Switch box		Switch lever
4x18 Tapping		M4x20 Pan head
screw (4 pcs.)
		screw with WR
	Lever