Makita EM4351UH, EM4350UH, EM4350LH specifications Shaft pipe complete, Assembling, Disassembling

Page 4

P 4/ 22

Repair

[4]DISASSEMBLY/ASSEMBLY

[4]-2. Engine and Shaft (cont.)

ASSEMBLING

Assemble by reversing the disassembly procedure.

(1)Put Cable bracket between Flat washer 6 and middle Nut, and tighten them by turning lower nut, upper nut and the middle nut. (Fig. 7)

(2)Put Stopper on Inner cable end into Swivel, then adjust the above nuts so that 3mm to 4mm of play is left inside of Swivel under condition that Throttle lever is not pulled. (Fig. 7)

Note: Adjust the tension of Inner cable to prevent the stopper from being removed . (Fig. 7)

Fig. 7

Stopper on Inner cable end

Nut (upper)

 

Cable bracket of Insulator

Nut (middle)

Play: 3mm to 4mm

complete

 

 

Flat washer 6

Swivel

 

Nut (lower)

 

[4]-3. Shaft pipe complete

DISASSEMBLING

(1)Loosen two M6x30 Hex. socket head bolt (2pcs.) and remove Protector with Protector extension attached. (Fig. 8)

(2)Enlarge the space between the side wall of Protector cover and M5x14 Hex socket head bolt, and remove Protector cover from Shaft pipe complete. (Fig. 9)

(3)Remove two M5x14 Hex socket head bolts then remove Protector clamp.

(4)Loosen M6x30 Hex socket head bolt then remove Gear case assembly. (Fig. 10)

Fig. 8

Fig. 9

M6x30 Hex. socket

head bolt (2 pcs.)

Protector

Protector extension

Fig. 10

M5x14 Hex socket head bolt (2 pcs.)

 

Shaft pipe

 

complete

The side wall of

Gear case

assembly

Protector cover

 

Gear case assembly

M6x30 Hex

M5x14 Hex socket

head bolt (2 pcs.)

socket head bolt

 

Protector clamp

 

Image 4
Contents Specification Optional accessoriesStandard equipment EM4350UH EM4350LH EM4351UHNecessary Repairing Tools RepairAssembly Engine and ShaftAssembling Shaft pipe completeDisassembling Repair DISASSEMBLY/ASSEMBLY 4-3. Shaft pipe complete DISASSEMBLY/ASSEMBLY Gear case assembly Clutch shoe Clutch drum For 4351UH For 4350LH and 4350UHChecking Plug CAP Ignition systemChecking Spark Plug Removing Ignition Coil FlywheelMounting Ignition Coil Repair DISASSEMBLY/ASSEMBLY 4-9. Recoil starter Reel. FigsDISASSEMBLING/ Cleaning Carburetor Carburetor sectionRepair DISASSEMBLY/ASSEMBLY 4-10. Carburetor section Assembling CarburetorVacuum Leak Test of Carburetor Mounting CarburetorStop switch section Checking Stop SwitchFuel tube section Fuel Tube RoutingEngine block Ring gap Side rail Top ring Second ring Spacer Ring gapRepair DISASSEMBLY/ASSEMBLY 4-13. Engine block Valve section DISASSEMBLY/ASSEMBLY Tightening torque specifications EM4350UH