Repair
P 6/ 22
[4]DISASSEMBLY/ASSEMBLY
[4]-3. Shaft pipe complete (cont.)
ASSEMBLING
For 4351UH:
(1A) Insert Buffer rubber into Pipe housing so as to align the two grooves with the two ribs (Fig. 16) Set the four Buffer rubbers in place of Pipe housing. (Fig. 17)
(2A) Insert two projections of Clutch case into Buffer rubbers.
Insert two projections of Housing holder into the other Buffer rubbers, then tighten M5x18 Hex socket head bolt while holding Housing holder by hand. (Fig. 17)
Note: Make sure that Corrugate tube is put in the groove of Pipe housing. (Fig. 18)
(3A) Assemble by reversing the disassembly procedure.
For 4350UH and 4350LH:
Assemble by reversing the disassembly procedure.
Fig. 17
Fig. 16
Ribs of Pipe housing |
Grooves of |
Buffer rubber |
| Pipe housing |
|
Projections of Clutch case | Buffer rubber (4 pcs.) | Housing holder |
Fig. 18
Groove of Pipe housing | Corrugate tube |