C

A

B

C

A

B

Fig. 74

ASSEMBLING UNIFENCE TO UNIFENCE BODY

1.The fence (A) can be assembled to clamp plate (B) in either the horizontal position as shown in Fig. 74, or the vertical position as shown in Fig. 75. Make certain that the two lock knobs (C) are loose and slide fence (A) onto clamp plate (B) as shown. Then tighten the two lock knobs (C).

2.For most cutting operations, the bottom of the fence should be positioned slightly above the table surface. Loosen two lock knobs (C) Fig. 76, and place a thin object such as a scale (D) between the table and fence. Tighten two lock knobs (C).

Fig. 75

C

D

Fig. 76

BIESEMEYER T-SQUARE FENCE SYSTEM

ASSEMBLY INSTRUCTIONS

1. WARNING: DISCONNECT MACHINE FROM POWER SOURCE.

2.Assemble the front rail (A) Fig. 77 to front of saw table using the two 3/8-16 x 1-1/4″ long flat head Phillips screws (B), 7/8″ flat washers, lock washers and 3/8-16 hex nuts supplied. Screws (B) are inserted through the two holes in the front rail, and through the two through-holes in the front of the saw table, and fastened to the table with the flat washers, lockwashers, and hex nuts. IMPORTANT: Do not completely tighten front rail mounting hardware at this time.

A B

D

B

Fig. 77

Fig. 78

26

Page 26
Image 26
Delta 36-426 Biesemeyer T-SQUARE Fence System Assembly Instructions, Assembling Unifence to Unifence Body