Delta 36-426 Assembly Instructions, Assembling SAW Stand, Assembling SAW to Stand

ASSEMBLY INSTRUCTIONS

WARNING: MAKE SURE THE SAW IS SECURELY ATTACHED TO THE STAND BEFORE PERFORMING ANY CUTTING OPERATIONS. DO NOT OPERATE THIS MACHINE UNTIL YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION MANUAL.

ASSEMBLING SAW STAND

1.Assemble the dust chute and support panel (A) Fig. 8, to the inside of the front stand panel (B) with three #10 x 1/2″ sheet metal screws (C).

2.Insert four #10-32 x 1/2″ screws (D) Fig. 9 through support panel and dust chute. Install four #10-32 hex nuts (E) Fig. 9. NOTE: The front stand panel will have the saw identity labels facing you. Do not completely tighten the stand hardware at this time. Also, make certain the dust chute/support panel (A) Fig. 9, is located under the lip of front stand panel (B).

3.Assemble the other end of dust chute and support panel (A) Fig. 10, to rear stand panel (F) as shown with four #10-32 x 1/2″ screws and #10-32 hex nuts, which are shown at (C). NOTE: Do not completely tighten stand hardware at this time.

F

C

CA

Fig. 10

ASSEMBLING

SAW TO STAND

1.Turn saw table face down on a piece of cardboard to protect the table surface. Place stand (B) Fig. 11, onto saw (A). Align eight holes in the stand (B) with mounting holes in the saw (A) and fasten with eight 5/16"-18 screws, flat washers, lockwashers, and hex nuts one of which is shown at (C) Fig. 11. Assemble flat washers onto screws, place screws through holes, assemble lockwashers then hex nuts finger tight. Do not completely tighten hardware at this time.

2.Install four rubber feet (D) Fig. 11, on the end of each stand leg (B).

3.Turn saw table face up.

C

C

B

A

Fig. 8

E	D
	B
	A

Fig. 9

D

B

C

A

Fig. 11

11