Delta 36-426 instruction manual Ba C B

4.Assemble shelf support bracket (M) Fig. 48 to the table legs (A) using two U-clamps (N), 1/4″ flat washers, and 1/4-20 hex nuts (P). NOTE: Height adjustments to the bracket can be made later.

5.Fasten the front table support (F) Fig. 49 to the bottom of the table using two #8 x 3/4″ long self tapping wood screws (H) and (I) supplied. NOTE: The slots closer to the angles in the support (F) should be against the table and the vertical flange of the table support should be flush with the front edge of the table. NOTE: Screws (H) and (I) Fig. 49 should not be completely tightened to the table board at this time. NOTE: Make certain the end of the table support does not extend out past the table. NOTE: Screw (I) must be removed and reinstalled when table is mounted to the saw.

CAUTION: DO NOT OVER-TIGHTEN MOUNTING SCREWS. Over-tightening screws in particle board may cause them to strip.

6.Fasten the rear table support (A) Fig. 50 to the saw table. Insert a 3/8-16 x1″ hex head screw (B), through hole in rear support and table, place a 3/8″ washer onto the screw and thread a 3/8-16 hex nut onto screw and tighten. Repeat this process for the remaining hole. Hole (C) is not used on cast iron wing.

7.Assemble the three brackets (J) to the table adapter plate (K) using the three 1/4-20 x 3/4″ carriage bolts, nuts and washers (Fig. 51). NOTE: The long leg of the brackets

(J) should be against the adapter plate (K). Do not completely tighten brackets (J) to adapter plate (K) at this time.

8.Fasten the table adapter plate (B) Fig. 52 to the right side of the saw table. Place a 7/16″ lockwasher onto a 7/16-20 x1″ hex head screw (D), insert screw through the table adapter plate and thread screw into right side of saw table. Repeat this process for the two remaining holes. NOTE: Before tightening screws (D), use a straight edge to make sure top of the adapter plate (B) is level with or slightly below surface of the saw table. Also make sure that the front edge of the adapter (B) does not stick out past the front edge of the saw table.

N

M

N

P

Fig. 48

H

F

I

Fig. 49

D

BA C B

Fig. 50

K J

Fig. 51

D

B

Fig. 52

21