Delta 36-426 instruction

Limited Edition 10″ Contractor’s Saw

with 30″ Unifence® (Model 36-426)

with 30″ Biesemeyer® (Model 36-431)

PART NO. 422-19-651-0050 - 05-28-02

Copyright © 2002 Delta Machinery

INSTRUCTION MANUAL

To learn more about DELTA MACHINERY

visit our website at: www.deltamachinery.com.

For Parts, Service, Warranty or other Assistance,

please call 1-800-223-7278 (In Canada call 1-800-463-3582).

Image 1

Delta 36-426 instruction manual Limited Edition 10″ Contractor’s Saw

Contents

Limited Edition 10″ Contractor’s Saw General Safety Rules Properly Support Long or Wide workpieces Additional Safety Rules for Table Saws Grounding Instructions Power Connections Minimum Gauge Extension Cord Extension Cords Unpacking and Cleaning Unifence T-SLOT Rail Fence System Unpacking Biesemeyer T-SQUARE Fence System 1718 Page Assembling SAW Stand Assembly InstructionsAssembling SAW to Stand Motor Assembling Blade Tilting HandwheelAssembling Motor to Motor Mounting Plate Assembling Motor and Motor Mounting Plate to SAW Page Connecting Motor Cord to Switch Assembly Assembling Blade Guard and Splitter Assembly If an alignment is necessary, loosen the two screws Page Assembling Extension Wing Assembling Switch to Extension Wing Unifence Assembly Instructions Assembling Table Board to SAW BA C B Assembling Unifence Table to SAW Assembling Unifence Guide Rail Assembling Rail Stop Setting T-SLOT Rail Stop Assembling Unifence Body to Guide Rail Assembling Cursor to Unifence Body Assembling Unifence to Unifence Body Biesemeyer T-SQUARE Fence System Assembly InstructionsPage 8″ M ″ L 4 ″ K Page Starting and Stopping SAW Locking Switch OFF PositionOverload Protection Tilting the Blade Raising and Lowering the Blade Checking Blade Alignment Miter Gage Operation and Adjustment Adjusting Blade Alignment Changing the SAW Blade Adjusting Table Insert Dust Chute Storing the Miter GAGE, RIP FENCE, and Arbor WrenchesFence Operation Adjusting Fence Parallel to Miter Gage Slots Adjusting Clamping Action of Fence Locking Handle Adjusting Fence Degrees to TableRepositioning Motor for Storage Protecting Cast Iron Table from Rust Common Sawing OperationsCROSS-CUTTING Unifence can be Used AS a CUT-OFF Gage For Unifence Systems only Constructing a Push Stick Ripping with the Unifence Ripping on Left Side of SAW Blade Using Auxiliary Wood Facing on RIP Fence Using Accessory Moulding Cutterhead Shows a typical dado operation using Miter gage as a guide Using Accessory Dado Head Constructing a Featherboard Biesemeyer T-SQUARE Fence System Fence Operation Adjusting Fence Parallel to Miter Gage Slots Lubrication Adjusting Clamping Action of Fence Locking Handle Constructing a Push Stick Pushstick Deluxe Uniguard Blade Guard Blade Guard Accessories Accessories Page Page Canadian PORTER-CABLE Delta Service Centers