Pushstick, Constructing a Push Stick | Delta 36-426 specification

CONSTRUCTING A PUSH STICK

When ripping work less than 4 inches wide, a push stick should be used to complete the feed and could easily be made from scrap material by following the pattern shown in Fig.150.

PUSHSTICK

MAKEFROM1/2″ OR3/4″ WOODORTHICKNESS LESSTHANWIDTHOF MAT’L.TOBECUT

NOTCHTOHELP PREVENTHAND FROMSLIPPING

CUTOFFHERETO PUSH1/4″WOOD

CUTOFFHERETO PUSH1/2″ WOOD

1/2″ SQUARES

Fig. 150

47

Image 47

Delta 36-426 instruction manual Pushstick, Constructing a Push Stick

Contents

Limited Edition 10″ Contractor’s Saw General Safety Rules Properly Support Long or Wide workpieces Additional Safety Rules for Table Saws Grounding Instructions Power Connections Minimum Gauge Extension Cord Extension Cords Unpacking and Cleaning Unifence T-SLOT Rail Fence System Unpacking Biesemeyer T-SQUARE Fence System 1718 Page Assembling SAW to Stand Assembly InstructionsAssembling SAW Stand Assembling Motor to Motor Mounting Plate Assembling Blade Tilting HandwheelMotor Assembling Motor and Motor Mounting Plate to SAW Page Connecting Motor Cord to Switch Assembly Assembling Blade Guard and Splitter Assembly If an alignment is necessary, loosen the two screws Page Assembling Extension Wing Assembling Switch to Extension Wing Unifence Assembly Instructions Assembling Table Board to SAW BA C B Assembling Unifence Table to SAW Assembling Unifence Guide Rail Assembling Rail Stop Setting T-SLOT Rail Stop Assembling Unifence Body to Guide Rail Assembling Cursor to Unifence Body Assembling Unifence to Unifence Body Biesemeyer T-SQUARE Fence System Assembly InstructionsPage 8″ M ″ L 4 ″ K Page Overload Protection Locking Switch OFF PositionStarting and Stopping SAW Tilting the Blade Raising and Lowering the Blade Checking Blade Alignment Miter Gage Operation and Adjustment Adjusting Blade Alignment Changing the SAW Blade Adjusting Table Insert Fence Operation Storing the Miter GAGE, RIP FENCE, and Arbor WrenchesDust Chute Adjusting Fence Parallel to Miter Gage Slots Repositioning Motor for Storage Adjusting Fence Degrees to TableAdjusting Clamping Action of Fence Locking Handle CROSS-CUTTING Common Sawing OperationsProtecting Cast Iron Table from Rust Unifence can be Used AS a CUT-OFF Gage For Unifence Systems only Constructing a Push Stick Ripping with the Unifence Ripping on Left Side of SAW Blade Using Auxiliary Wood Facing on RIP Fence Using Accessory Moulding Cutterhead Shows a typical dado operation using Miter gage as a guide Using Accessory Dado Head Constructing a Featherboard Biesemeyer T-SQUARE Fence System Fence Operation Adjusting Fence Parallel to Miter Gage Slots Lubrication Adjusting Clamping Action of Fence Locking Handle Constructing a Push Stick Pushstick Deluxe Uniguard Blade Guard Blade Guard Accessories Accessories Page Page Canadian PORTER-CABLE Delta Service Centers