7.Lift the motor and assemble the drive belt (H) Fig. 23 to the arbor pulley and motor pulley (B). The weight of the motor will provide the correct belt tension.
8.
WARNING: IMMEDIATELY AFTER ASSEMBLING THE BELT, RAISE THE SAW BLADE TO ITS MAXIMUM HEIGHT AND TILT THE SAW BLADE TO 45 DEGREES. CHECK TO SEE IF THE MOTOR (J) FIG. 24 IS BELOW THE TOP OF THE TABLE SURFACE (K). IF THE MOTOR (J) IS ABOVE THE TOP OF THE TABLE SURFACE, MOVE THE MOTOR TO THE LEFT UNTIL THE END BELL (J) OF THE MOTOR IS BELOW THE TOP OF THE TABLE SURFACE. THEN
9.Assemble the outer cover (E) Fig. 25, of the belt and pulley guard assembly, which was removed in STEP 3, and fasten with external tooth lockwasher and wing nut
(D). IMPORTANT: Make certain the outer cover does not interfere with the drive belt and the motor pulley.
CONNECTING MOTOR CORD TO SWITCH ASSEMBLY
WARNING: BEFORE CONNECTING MOTOR CORD TO THE SWITCH ASSEMBLY, MAKE CERTAIN THE MACHINE IS DISCONNECTED FROM THE POWER SOURCE.
1.Insert the pronged motor plug (A) Fig. 26, into the female receptacle (B) of
H
B
Fig. 23
J
K
Fig. 24
D
E
Fig. 25
C
B
A
Fig. 26
15
