clockwise until it stops and completely covers the orange threads as shown in figure 16.
3. Repeat steps 1 and 2 above to attach the saw head module to the center
extension. Always check to
makeWARNING:sure that the sleeve is completely threaded on and that the orange threads are no longer visible. Not threading the sleeve completely on could result in the modules becoming disconnected creating a hazardous condition. Periodically check the connections to insure that no orange threads are visible.
DISASSEMBLY
Detaching Saw Head Module
Sharp moving blade. To prevent
accidentalWARNING:operation, insure that battery is disconnected from the handle and that the protective scabbard is in place on the chain before performing the following operations. Failure to do this could result in serious personal injury.
When detaching the modules, whether it is in the two module or three module mode, always detach the saw head module first. Todo this, rest the handle module on the ground and grasp the center of the saw head module with one hand figure 17.
Use your other hand to loosen the threaded sleeve figure 18 and then pull the two halves apart. Repeat this process if the center extension was attached.
OPERATING THE POLE SAW | ||
WARNING: Read and understand all instructions. Failure to | ||
follow all instructions listed below may result in electric shock, fire | ||
and/or serious personal injury. |
|
|
Connecting the Battery |
| 19 |
Place the battery in the tool as shown in figure | ||
19 and be certain that it is inserted fully into the |
| |
tool cavity until it “clicks” into place. To remove |
| |
the battery from the tool, press down on the |
|
|
release button on the back of the battery (figure |
| |
20) and slide out. |
| 20 |
|
| |
Switch |
|
|
Always be sure of your footing and grip the | 21 |
|
Pole Saw firmly with both hands with the |
| |
thumb and fingers encircling the handle. |
|
|
Toturn the tool ON pull the lock button (1) |
|
|
back with your thumb and then squeeze |
|
|
the trigger (2) with your fingers as shown |
|
|
in figure 21. (Once the tool is running you |
|
|
can release the lock button.) Toturn the |
|
|
tool OFF,release the trigger. |
|
|
|
|
|
Your chain saw is fitted with an | ||
will stop the chain quickly each time you release the rear trigger, or if | ||
kickback should occur. This system should be tested before every | ||
use. |
|
|
12
