Transporting Pole Saw
• Always remove the battery pack from the 7 handle (figure 7) and cover the chain with the scabbard (figure 8) when transporting the Pole Saw. See page 8 for additional information on transporting the battery.
8
ASSEMBLY
Joining Saw Head Module to Handle Module 
Sharp moving blade. To prevent accidental
operation,WARNING:insure that battery is disconnected from the handle and that the protective scabbard is in place on the chain before performing the following operations. Failure to do this could result in serious personal injury.
The three modules which make up the Pole Saw are keyed to insure correct assembly. If a module does not smoothly attach to another do not force fit.
Combining the handle module (A) to the saw head module (C) creates a pole saw that is approximately 6 foot in length as shown in figure 9. 9
Toattach the handle module to the saw head module:
1. Align the groove on the outside of the coupling end of the handle module (A) with the tongue on the inside of the coupling end of the saw head module (C). See figure 10. Push the two sections completely together.
2. Slide the threaded sleeve (6) figure 11 on the saw head module down as far as possible and rotate the sleeve clockwise
until it stops and completely covers the Groove orange threads as shown in figure 12.
Always check to
makeWARNING:sure that the sleeve is completely threaded on and that the orange threads are no longer visible. Not threading the sleeve completely on could result in the modules becoming disconnected creating a hazardous condition. Periodically check the connections to insure that no orange threads are visible.
Joining Center Extension to Saw Head Module and Handle Module
Adding the extension (B) to the handle module (A) and saw head module (C) creates a Pole Saw that is approximately 9 foot in length as shown in figure 13.
To attach the middle module to the handle | 14 |
module and saw head module: | |
1. Align the groove on the outside of the |
|
coupling end of the handle module (A) | Groove |
with the tongue on the inside of the | |
coupling end of the center extension |
|
(B). See figure 14. Push the two |
|
sections completely together. |
|
2. Slide the threaded sleeve (6) (figure |
|
15) on the center extension down as far |
|
11 as possible and rotate the sleeve |
|
