![](/images/new-backgrounds/1113184/11318435x1.webp)
Removing chip buildup
Chips and sawdust will build up in the guide bar groove and oil hole, clogging them and impairing oil flow. Remove the guide bar and clean them out.
Clean out
Guide bar
Fig. 2
Replacingcarbon brushes
Remove and check the carbon brushes regularly. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced a t the
same time. Use only Makita carbon brushes. | / | Limit mark |
| ||
Use a screwdriver to remove the brush |
|
|
holder caps. Take out the worn carbon |
|
|
brushes, insert the new ones and secure the |
|
|
brush holder caps. |
|
|
Storing the tool
Before storing the tool, be sure td do the following:
0Remove the chain cover. Remove any chips and sawdust from the tool.
0 Install the chain cover. Turn the tool on and depress the oil button 4 or 5 times.
.Cover the saw chain and the guide bar with the scabbard.
To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts.
18