Simplicity ZT4000 Series manual General Operating Safety, Checks Before Starting

Page 18

Operation

Operation

General Operating Safety

Before first time operation:

•Be sure to read all information in the Safety and Operation sections before attempting to operate this tractor and mower.

•Become familiar with all of the controls and how to stop the unit.

•Drive in an open area without mowing to become accustomed to the unit.

WARNING

Operating on steep slopes can be dangerous.

•Never operate on slopes greater than 15°.

•Select slow ground speed before driving onto a slope. Use extra caution when operating on slopes with a rear- mounted grass catcher.

•Mow across the face of slopes, not up and down, use caution when changing directions and DO NOT START OR STOP ON A SLOPE.

WARNING

•Never allow passengers to ride on the unit.

•Before leaving the operator’s position for any reason, engage the parking brake, disengage the PTO, stop the engine and remove the key.

•To reduce fire hazard, keep the engine, tractor and mower free of grass, leaves and excess grease. Do NOT stop or park tractor over dry leaves, grass or combustible materials.

•Gasoline is highly flammable and must be handled with care. Never fill the tank when the engine is still hot from recent operation. Do NOT allow open flame, smoking or matches in the area. Avoid over-filling and wipe up any spills.

Checks Before Starting

•Check that crankcase is filled to full mark on dipstick (B, Figure 1). See the engine Operator’s Manual for instructions and oil recommendations.

•Make sure all nuts, bolts, screws and pins are in place and tight.

•Adjust the seat position (C), and make certain you can reach all the controls from operator’s position.

•Fill the fuel tank (A) with fresh fuel. Refer to the engine manual for fuel recommendations.

C

A

B

Figure 1. Pre-start Checks

A.Fuel Tank Cap

B.Crankcase Oil Fill

C.Seat Adjustment Lever

WARNING

•Do NOT load this zero-turn rider on a trailer or truck using two separate ramps. Only use a single ramp that is at least one foot wider than the width of the rear wheels of this rider. This rider has a zero turning radius and the rear wheels could fall off the ramps, or the rider could tip over injuring the operator or bystanders.

16	www.simplicitymfg.com

Image 18

Contents 24HP Zero-Turn Riders Mfg. No Description 5900707 26HP Zero-Turn RidersMfg. No Description 5900765 Date Purchased Table of Contents Operating Safety Read the ManualChildren Slope Operation Thrown ObjectsMoving Parts Roll Bar Use Retaining Walls, Drop-offs, and WaterOverhead Obstacles Fuel and Maintenance Enclosed AreasGeneral Operation Transporting and StorageIgnition System Towed Equipment Ride-On UnitsEmissions Operating on steep slopes can be dangerousService and Maintenance Service & MaintenanceSafe Handling of Gasoline Roll Bar Instructions Operational WarningsInspection of the Roll Bar Protective Structure Inspection and Maintenance of the Roll Bar Seat Belt Safety Decals Objects HazardSafety Icons Safety Interlock SystemOperational Safety Checks North American Safety IconsCE Identification Tag Markings Identification NumbersCE Models North American ModelsPTO Power Take Off Switch Parking BrakeChoke Seat Adjustment Lever Ignition SwitchHour Meter / Maintenance Reminder Throttle ControlGeneral Operating Safety Checks Before StartingPushing the Rider by Hand Seat AdjustmentCheck Tire Pressures OperationMowing Height Adjustment Foot Pedal AdjustmentTo Adjust Pedal Position Starting the Engine Stopping the RiderZero-Turn Driving Practice Smooth TravelForward Travel Practice Practice Turning Around a Corner Executing an End-Of-Row Zero TurnPractice Turning In Place Mowing Recommendations StorageMowing Fire or explosion can cause severe burns or deathMowing Methods Mulching Requires Excellent Mowing Conditions Attaching a TrailerProper Mulching How Much Grass to MulchMaintenance Schedule Check Rider / Mower for loose hardwareChange Oil & Filter Checking / Adding FuelFuel Filter Inspect Muffler and Spark ArresterBattery Maintenance Check Hydraulic Oil LevelChange Hydraulic Oil Filter Oil LubricationGrease Lubricating the Front CastersServicing The Mower Blades Inspecting the Mower BladesReinstalling the Mower Blades Balancing the Mower Blade NailGround Speed Control Lever Adjustment Speed Balancing AdjustmentNeutral Adjustment Return-to-Neutral AdjustmentTo Adjust Parking Brake Adjustment Hydraulic Pump Drive Belt ReplacementRear Suspension Adjustment To adjust the spring pre-loadSpring loaded components can kick back causing injury Deck Lift Rod Timing And Leveling Adjustment Mower Belt Replacement Mower PTO Belt Idler Arm Stationary Idler PulleyTroubleshooting Troubleshooting the RiderTroubleshooting the Rider Troubleshooting the MowerTroubleshooting Common Cutting Problems StreakingHP Briggs & Stratton HydroGear PG-3H / HGM-12EDeck Indentification Product Quick Specs