OPERATING INSTRUCTIONS
GETTING TO KNOW YOUR HAND HELD TRIMMER
Adjusting the Blade Cover
WARNING: Always remove battery before adjusting the blade cover.
The hand held trimmer can be transformed from trimmer mode to edging mode easily.
1.Grasp the blade cover on the hand held trimmer and turn the handle of the trimmer 180° counter clockwise. (Fig. 8)
Fig. 8
2.To use as an edging tool, keep the protective blade guard in direction of area being edged. (Fig. 9)
Fig. 9
Changing the Blades
This hand held trimmer has two blades, they must be changed at the same time to ensure that the product stays balanced. If your hand held trimmer vibrates when in use, check that both blades are worn evenly.
To remove blades:
1.Always remove the battery before servicing your hand held trimmer.
2.Hold the blade hub with one hand. With the other hand, hold the blade and push in towards the center of the
hub. (Fig. 10) Repeat for second blade and dispose
of used blades in normal waste.
3.Hold the new blade in the center and place over the metal lug. Pull away from the center of the blade hub until you feel it snap into place. (Fig. 11) Repeat for the second blade.
Fig. 11
Storage
WARNING: To avoid serious personal injury, be sure that the
battery pack is removed from unit before cleaning or performing any kind of maintenance on the unit.
1.Fully discharge the battery (by running the unit) and then recharge the battery for 10 hours.
2.Remove any build up of debris, and wipe all exterior surfaces with a dry lint free cloth.
3.Remove the battery and store in a dry place, away from the reach of children.
4.Always store the unit indoors to prevent damage to the unit.
5.Once a month run the unit until the battery is exhausted and then immediately charge for at least 10 hours.
NOTE: It is not necessary to oil this unit.
1. | Blade Cover | 8. | Charging Adapter |
2. | Blade (x 3 Sets) | 9. | Ni Cd Battery |
3. | Trigger Safety Interlock | 10. | Charging Jack |
4. | On/Off Trigger | 11. | Battery Compartment |
5. | Charging Base | 12. | Battery Release Buttons |
6. | Charging Jack Receptacle | 13. | Protective Blade Guard |
7. | LED Charging Light | 14. | Handle |
Illustrations may differ from actual product.
NOTE: Hand held trimmer is shipped with the batteries uncharged. Charging of the unit for 10 hours prior to first use is required.
Technical Specifications
Voltage: | 4.8 V DC |
Power: | 20 Watts |
7
4