Poulan S31SNGBC Carton Contents, Tools Required, Installing Brushcutter Attachment

age in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek med- ical attention. An anti--vibration system does not guarantee the avoidance of these prob-

lems. Users who operate power tools on a continual and regular basis must monitor closely their physical condition and the condi- tion of this tool.

SPECIAL NOTICE: This unit is equipped with a temperature limiting muffler and spark arresting screen which meets the require- ments of California Codes 4442 and 4443. All

U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Ore- gon, and Washington require by law that many internal combustion engines be equipped with a spark arresting screen. If you operate in a locale where such regulations ex- ist, you are legally responsible for maintaining the operating condition of these parts. Failure to do so is a violation of the law. For normal homeowner use, the muffler and spark arrest- ing screen will not require any service. After 50 hours of use, we recommend that your muffler be serviced or replaced by your autho- rized service dealer.

CARTON CONTENTS

Check carton contents against the following list:

Coupler

LOOSEN

SPowerhead

S	Brushcutter attachment
S	Blade shield screws (4)
S	Cupped washer
S	Large nut for installing blades
S	Hex wrench
S	Metal shield
S	Plastic shield
S	Shoulder strap with warning

Shipping protector

TIGHTEN

Knob

S	4--point weed blade
S	Trimmer head (assembled on unit)
S	Handlebar (assembled on unit)
S	Wing nut (screwed onto shield)
S	Container of oil

WARNING: Always stop unit and dis- connect spark plug before performing any as- sembly procedures.

WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.

Examine parts for damage. Do not use dam- aged parts.

NOTE: If you need assistance or find parts missing or damaged, call 1-800-554-6723.

It is normal for the fuel filter to rattle in the empty fuel tank.

Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.

TOOLS REQUIRED

SHex wrench (provided) S Adjustable wrench

INSTALLING BRUSHCUTTER

ATTACHMENT

CAUTION: When installing brushcutter at- tachment, place the unit on a flat surface for stability.

1.Loosen the coupler by turning the knob counterclockwise.

4

2.Remove shipping protector from coupler.

3.Remove the tube cap from the brushcutter attachment (if present).

4.Position locking/release button of attach- ment into guide recess of coupler.

5.Push the attachment into the coupler until the locking/release button snaps into the primary hole.

6.Before using the unit, tighten the knob se- curely by turning clockwise.

Coupler	Primary Hole
		Guide Recess
Upper	Locking/	Lower
	Release
Tube		Attachment
	Button

WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole.

For optional attachments, see the AS- SEMBLY section of the applicable attach- ment instruction manual.

ADJUST AND SECURE THE HAN- DLEBAR

DANGER: To avoid serious injury, the barrier portion of the handlebar must be ad- justed and remain installed as shown to pro- vide a barrier between operator and the spin- ning blade. The handlebar clamp must be positioned between the arrows on the handle- bar decal.