Basic Care
The following should be performed on the tool when applicable:
¥Blow off dirt, dust and debris from the tool and out of the air vents.
¥Maintain a sharp edge on your blades for the best performance.
¥Clean the power cord and coil it neatly when the tool is not in use.
¥Repair or replace damaged parts.
¥Keep the blade safety cover on when the tool is not in use.
Cleaning Shear
Use a good solvent to clean the jaw assembly of the shear. Avoid getting sol- vent on the plastic body of the shear as it may damage the plastic. Always be sure that the shear is dry before using it again.
Do not allow dust, chips, sand, etc. into the air vent holes. This could lead to motor fail- ure and premature bushing failure.
Never use use gasoline or other flam- mable liquids to clean this tool. Vapors in the tool may ignite, causing the tool to explode. Ignoring this warning may lead to serious personal injury or even death!
H5503 14 Gauge Swivel Head Shears