Grizzly H5503 instruction manual Changing Blades, To change the blades

Page 8

Changing Blades

To change the blades:

1.Make sure the tool is disconnected from the power supply.

2.Unscrew the three cap screws in the head of the shears and set them aside.

3.Remove the head assembly from the main body of the shear by pulling it forward (Figure 5).

Figure 5. Shear head removal.

-6-

4.Remove the middle blade and side blades from the housing. Keep the spacer bushing for re-assembly.

5.Sharpen or replace the blades.

6.Install the blades back into the hous- ing.

NoteÑ Reassemble the blades back into the housing the same way they were taken out. Make note of their orientation.

7.Place the head around the gear box cover ring and tighten the cap screws to lock it into position.

H5503 14 Gauge Swivel Head Shears

Image 8

Contents Gauge Swivel Head Shears Model H5503Page Safety Before Operating This EquipmentAMP Length Rating Introduction CommentaryOperation Test RunPreparing For Operation Swivel HeadCutting Trigger Lock To start a cutting operationChanging Blades To change the bladesChanging Motor Brushes MaintenanceLubrication Cleaning Shear Basic CareH5503 14 Gauge Swivel Head Shears H5503 14 Gauge Swivel Head Shears Description Warranty and Returns Warranty Card Place Stamp Here