How to trim and edge, Spool Cap, Use

How to trim and edge

M	1
M
	2

To start your trimmer

1.Hold as illustrated in Fig M.

2.To start, press lock-off button (M1), squeeze the switch lever (M2), release

lock-off button.

How to trim

1.	Cut with nylon line at an angle using the tip.
	See Fig N
2.	Swing trimmer in and out of the cutting area

O
P	Q

taking small cuts (O)

3. Line is fed out automatically every time the

trimmer head stops rotating and returns to

operating speed.

•Extra line can be fed out manually as described on page 9.

4.To stop your trimmer release the switch

lever (M2).

How to edge

1.	To convert to edging mode, depress locking
	button and twist head anti-clockwise until
	arrow lines up with "EDGE". An audible
	"click" will confirm that the head is locked.
	Ensure the button has returned to its
	original position. See Fig P.
2.	Rest edger on roller for extra stability and
	line up with edge of lawn. See Fig R. Edge
	in direction indicated in Fig Q. so that

debris is thrown away from you.

3. To return to trimming mode, depress

locking button and twist head clockwise

until arrow lines up with "TRIM". An audible

"click" will confirm that the head is locked.

Ensure the button has returned to its

original position. See Fig S.

Spool Cap

USE

	T	cap
	T	release
		release
		latches
	U	cap

To remove spool cap

1.Press and hold in the two cap release latches. See Fig T.

2.Pull cap away from the cutting head. See

Fig U.

When refitting the spool cap

1.	Keep all areas of the cap and spoolholder
	clean. Failure to do so may prevent the
	cap being securely located in the
	spoolholder.
2.	Align the two latches on the cap with the
	two windows in the spoolholder, then press
	down into the locked position.

spool

manual line feed button

spoolholder

eyelet

3.	Ensure the two cap release latches are
	clearly visible and are fully engaged with
	the windows in the spoolholder.
4.	Check that the cap is correctly fitted by
	trying to remove it without depressing the
	two latches.