7
Handle Adjustment
I | bolt |
1. Attach steady handle to product using bolt and handle knob as shown in Fig I.
2. Adjust the steady handle to a comfortable |
| handle |
operating position, see Fig J., by |
| |
| knob | |
unscrewing the handle knob, springing the |
| |
|
| |
side lugs apart, moving the handle to the |
|
|
required position, carefully | J | K |
teeth and then tightening the handle knob. | ||
See Fig K. |
|
|
Auto Line Feed System
ADJUSTMENT
How the automatic line feed works (L)
1. A short length of new line is fed out every time you switch on, this is caused by the cutting head accelerating up to its full speed.
2.To feed more line, it is necessary to switch- off, allow the motor to stop and then restart. When edging do this frequently.
3.When the line feeds you will hear a change in the motor sound as well as the noise generated by the line being cut to its length.
4.If the line does not feed see Fault Finding Hints for further information.
L |
line cutter |