Poulan BC3150 instruction manual Operation

Page 7

8.Insert a small screwdriver into aligned holes. This will keep the shaft from turn- ing while tightening the blade nut.

Screwdriver

9.TIghten blade nut firmly with a wrench while holding screwdriver in position.

10.Remove the screwdriver.

11.Turn blade by hand. If the blade binds against the shield, or appears to be uneven, the blade is not centered, and you must re- install.

NOTE: To remove blade, insert screwdriver into aligned holes. Unthread the nut and re- move parts. Be sure to store parts and instruc- tions for future use.

OPERATION

KNOW YOUR UNIT

READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT. Compare the illustrations with your unit to familiarize yourself with the location of the various controls and adjustments. Save this manual for future reference.

 

 

Handlebar

Trimmer Head

Shaft

 

Line Limiter

ON/OFF Switch

Shield

Blade

 

 

 

Starter Handle

 

 

Primer Bulb

 

Throttle Trigger

 

Blade

 

 

 

Choke

Muffler

 

Lever

 

 

ON/OFF SWITCH

The ON/OFF switch is located on the trigger handle and is used to stop the engine. Move the switch to the OFF position to stop the engine.

PRIMER BULB

The PRIMER BULB removes air from the car- buretor and fuel lines and fills them with fuel. This allows you to start the engine with fewer pulls on the starter rope. Activate the primer bulb by pressing it and allowing it to return to its original form.

CHOKE

The CHOKE helps to supply fuel to the engine to aid in cold starting. Activate the choke by moving the choke lever to the FULL CHOKE position. After the engine attempts to start, move the choke lever to the HALF CHOKE position. Once engine has started, move the choke lever to the OFF CHOKE position.

BEFORE STARTING ENGINE

WARNING: Be sure to read the fuel information in the safety rules before you be- gin. If you do not understand the safety rules, do not attempt to fuel your unit. Call 1-800-554-6723.

FUELING ENGINE

WARNING: Remove fuel cap slowly when refueling.

HELPFUL TIP

To obtain the correct oil mix ratio, pour 3.2 ounces of 2-cycle synthetic oil into one gallon of fresh gas.

This engine is certified to operate on un- leaded gasoline. Before operation, gasoline must be mixed with a good quality synthetic 2-cycle air-cooled engine oil designed to be mixed at a ratio of 40:1. Poulan/Weed Eater brand synthetic oil is recommended. Mix gaso-

7

Image 7
Contents 11/19/04 Manual de Instrucciones Manuel d’InstructionsLeg protection Safety RulesOperator Safety Hazard ZoneTransporting and Storage UNIT/MAINTENANCE SafetyFuel Safety Cutting SafetyAssembly Assembly Information Trimmer Head Configuring Your UnitAttaching the Plastic Shield and Trimmer Head Washer Cupped Nut Assembly Information Weed BladeInstallation of the Metal Blade Attaching the Metal ShieldOperation See the Storage section for additional in- formation HOW to Stop Your UnitHOW to Start Your Unit Switch Throttle TriggerOperating Instructions for USE with Trimmer Head Starting a Warm EngineStarting a Flooded Engine Operating PositionOperating Instructions for USE with Weed Blade Cutting MethodsCheck for Damaged or Worn Parts MaintenanceInspect and Clean Unit and DE- Cals Check for Loose Fasteners and PartsService and Adjustments Other Seasonal StorageFuel System EngineTroubleshooting Table Cause Remedy Ligations The U.S. Environmental Limited WarrantyTies As the small off--road engine engine Intermediate 125 hours Extended 300 hours