HOW to Start Your Unit

Engine Choke Lever

ON/STOP

Switch

FULL HALF OFF

WARNING: The trimmer head will turn while starting the engine. Avoid any con- tact with the muffler. A hot muffler can cause serious burns.

STARTING A COLD ENGINE (or a warm engine after running out of fuel)

Starting Position

1.Set unit on a flat surface.

2.Slowly press the primer bulb 6 times.

3.Move choke lever to the FULL CHOKE posi- tion.

4.Squeeze the throttle trigger fully and hold through all remaining steps.

Starter Handle

Choke

Lever

flooded. Proceed to STARTING A FLOODED ENGINE.

8.Once the engine starts, allow it to run 10 seconds, then move the choke lever to the OFF CHOKE position. Allow the unit to run for 30 more seconds at OFF CHOKE be- fore releasing the throttle trigger.

NOTE: If engine dies with the choke lever in the OFF CHOKE position, move the choke lever to the HALF CHOKE position and pull the rope until engine runs, but no more than 6 pulls.

STARTING A WARM ENGINE

1.Move the choke lever to the HALF CHOKE position.

2.Squeeze and hold the throttle trigger. Keep throttle trigger fully squeezed until the engine runs smoothly.

3.Pull starter rope sharply until engine runs, but no more than 5 pulls.

4.Allow engine to run 15 seconds, then move the choke lever to OFF CHOKE.

NOTE: If engine has not started, pull starter rope 5 more pulls. If engine still does not run, it is probably flooded.

STARTING A FLOODED ENGINE

Flooded engines can be started by placing the choke lever in the OFF CHOKE position; then, pull the rope to clear the engine of ex- cess fuel. This could require pulling the starter handle many times depending on how badly the unit is flooded.

If the unit still doesn’t start, refer to TROUBLESHOOTING TABLE or call 1-800-554-6723.

OPERATING INSTRUCTIONS

It is recommended that the engine not be operated for longer than 1 minute at full throttle.

OPERATING POSITION

ALWAYS WEAR:

Eye Protection

Muffler

Long Pants

Primer Bulb

Heavy Shoes

5.Pull starter rope handle sharply until engine sounds as if it is trying to start, but do not pull rope more than 6 times.

6.As soon as engine sounds as if it is trying to start, move choke lever to HALF CHOKE position.

7.Pull starter rope sharply until engine runs, but no more than 6 pulls.

NOTE: If the engine doesn’t start after 6 pulls (at the HALF CHOKE position), move the choke lever to the FULL CHOKE position and press the primer bulb 6 times. Squeeze and hold the throttle trigger and pull the starter rope 2 more times. Move the choke lever to the HALF CHOKE posi- tion and pull the starter rope until the en- gine runs, but no more than 6 pulls. If the engine still doesn’t start, it is probably

Cut from your right to your left.

WARNING: Always wear eye protec- tion. Never lean over the trimmer head. Rocks or debris can ricochet or be thrown into eyes and face and cause blindness or other serious injury.

Do not run the engine at a higher speed than necessary. The cutting line will cut efficiently when the engine is run at less than full throttle. At lower speeds, there is less engine noise and vibration. The cutting line will last longer and will be less likely to “weld” onto the spool.

Always release the throttle trigger and allow the engine to return to idle speed when not cutting.

FX25 LE, XT250 LE specifications

The Poulan FX25 LE and XT250 LE are two powerful trimmers designed to meet the demands of landscaping professionals and homeowners alike. Packed with innovation, these models stand out in terms of performance, user comfort, and usability.

At the heart of the Poulan FX25 LE is a robust 25cc 2-stroke engine. This engine provides ample power for tackling thick grass, stubborn weeds, and overgrown areas with ease. The XT250 LE features a slightly larger 26cc engine, enhancing its capabilities for heavier-duty tasks. The engines are designed for efficiency, delivering excellent fuel economy while maintaining a high-power output, essential for prolonged use.

Both models incorporate advanced starting technology. The Easy Start feature ensures that users can get their trimmers running effortlessly, reducing the frustration commonly associated with starting small engines. These trimmers are equipped with an automatic choke, enhancing their user-friendliness, especially for those who may not be familiar with two-stroke engines.

Another highlight of these models is their lightweight design, which significantly reduces user fatigue during extended periods of operation. Weighing in at less than 10 pounds, they are easy to maneuver, making them ideal for trimming delicate landscapes and navigating tight corners.

The Poulan FX25 LE and XT250 LE come with ergonomically designed handles that provide a comfortable grip, allowing for prolonged usage without compromising control. The adjustable harness on the XT250 LE not only adds comfort but also distributes weight more evenly, adding to the ease of operation.

Additionally, both trimmers feature a dual-line cutting system, which provides a wider cutting path to enhance efficiency. The rapid reload spool allows users to replace the line quickly and easily without the need for additional tools. This feature saves time and ensures that users spend more time trimming and less time on maintenance.

Durability is another significant aspect of these models. Constructed with high-quality materials, the Poulan FX25 LE and XT250 LE are built to withstand the rigors of outdoor use. They are also equipped with protective shields to safeguard the user from debris while operating.

In summary, the Poulan FX25 LE and XT250 LE trimmers offer a powerful, efficient, and user-friendly experience. With features such as robust engines, easy starting mechanics, lightweight design, ergonomic handles, and a dual-line cutting system, they are well-suited for any landscaping task. Whether you are a homeowner maintaining your garden or a professional landscaper, these trimmers provide the reliability and performance necessary to achieve excellent results.