If the unit still doesn’t start, refer to TROUBLESHOOTING TABLE or call
OPERATING THE COUPLER
This model is equipped with a coupler which enables optional attachments to be installed. The optional attachments are:
MODEL:
Edger . . . . . . . . . . . . . . . . . . . . . PP1000E Cultivator . . . . . . . . . . . . . . . . . . PP2000T Blower . . . . . . . . . . . . . . . . . . . . PP3000B Pruner . . . . . . . . . . . . . . . . . . . . PP5000P
WARNING: Always stop unit and dis- connect spark plug before removing or instal- ling attachments.
REMOVING TRIMMER ATTACH- MENT (OR OTHER OPTIONAL ATTACHMENTS)
CAUTION: When removing or installing at- tachments, place the unit on a flat surface for stability.
1.Loosen the coupler by turning the knob counterclockwise.
Upper Shaft
Coupler
WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole unless otherwise stated in the applicable attachment instruction manual. Using the wrong hole could lead to seri- ous injury or damage to the unit.
Secondary Hole
Locking/Release
Button in Primary Hole
OPERATING INSTRUCTIONS
It is recommended that the engine not be operated for longer than 1 minute at full throttle.
OPERATING POSITION
ALWAYS WEAR:
Lower Attachment
LOOSEN
Hearing 
Protection
Eye Protection
Heavy,
Long Pants
TIGHTEN Knob
2.Press and hold the locking/release button. Locking/Release
Button
Coupler | Upper Shaft | |
Lower Attachment | ||
|
3.While securely holding the engine and upper shaft, pull the attachment straight out of the coupler.
INSTALLING OPTIONAL ATTACH- MENTS
1.Remove the shaft cap from the attach- ment (if present).
2.Position locking/release button of attach- ment into guide recess of coupler.
3.Push the attachment into the coupler until the locking/release button snaps into the primary hole.
4.Before using the unit, tighten the knob se- curely by turning clockwise.
Coupler | Primary Hole |
| Guide Recess |
| Locking/ |
Upper | Release Attachment |
Shaft | Button |
|
Boots
Cut from your left to your right.
When operating unit, clip shoulder strap onto clamp, stand as shown and check for the fol- lowing:
S Wear hearing protection, eye protection, head protection and heavy clothing.
S Extend your left arm and hold handlebar grip with your left hand.
SHold throttle grip with your right hand with
finger on throttle trigger.
SKeep unit below waist level.
SKeep shoulder strap pad centered on your
left shoulder and danger sign centered on your back.
S Maintain full weight of tool on your left shoulder.
S Without bending over, keep the blade or trimmer head near and parallel to the ground and not crowded into material being cut.
OPERATING INSTRUCTIONS FOR USE WITH TRIMMER HEAD
WARNING: Always wear eye protec- tion. Never lean over the trimmer head. Rocks or debris can ricochet or be thrown into eyes and face and cause blindness or other serious injury.
10