Poulan PP336 Edger Safety, BLOWER/VACUUM Safety, Cultivator Safety, Hedge Trimmer Safety

Page 13

Handlebar

EDGER SAFETY

WARNING: Inspect the area to be edged before each use. Remove objects (rocks, broken glass, nails, wire, etc.) which can be thrown by the blade or can wrap around the shaft.

SBlade rotates momentarily after the trigger is released. The blade can seriously cut

you or others.

SAllow blade to stop before removing it from the cut.

SThrow away blades that are bent, warped, cracked, broken or damaged in any other way. Replace parts that are cracked,

chipped, or damaged before using the unit. S Do not attempt to remove cut material nor hold material to be cut when the engine is running or when cutting blade is moving.

SAlways keep the wheel and depth adjusting

skid in contact with the ground.

S Always push the unit slowly over the ground. Stay alert for uneven sidewalks, holes in the terrain, large roots, etc.

S Always use the handlebar when using edger attachment.

BLOWER/VACUUM SAFETY

WARNING: Inspect area before starting unit. Remove all debris and hard ob- jects such as rocks, glass, wire, etc. that can ricochet, be thrown, or otherwise cause injury or damage during operation.

SDo not set unit on any surface except a clean, hard area while engine is running. Debris such as gravel, sand, dust, grass, etc., could be picked up by the air intake and thrown out through discharge opening, damaging unit,

property, or causing serious injury to bystanders or operator.

SNever place objects inside the blower tubes, vacuum tubes or blower outlet. Always direct the blowing debris away from people, animals, glass, and solid objects such as trees, automobiles, walls, etc. The force of air can cause rocks, dirt, or sticks to be thrown or to ricochet which can hurt people or animals, break glass, or cause other damage.

S Never run unit without the proper equipment attached. When using your unit as a blower, always install blower tubes.

SCheck air intake opening, blower tubes or vacuum tubes frequently, always with engine stopped and spark plug disconnected. Keep vents and discharge

tubes free of debris which can accumulate and restrict proper air flow.

SNever place any object in air intake opening as this could restrict proper air flow and cause damage to the unit.

SNever use for spreading chemicals, fertilizers, or other substances which may contain toxic

materials.

STo avoid spreading fire, do not use near leaf or brush fires, fireplaces, barbecue pits, ashtrays, etc.

CULTIVATOR SAFETY

WARNING: Rotating tines can cause serious injury. Keep away from rotating tines. Stop the engine and disconnect the spark plug before unclogging tines or making repairs.

WARNING: Inspect the area to be cultivated before starting the unit. Remove all debris and hard and sharp objects such as rocks, vines, branches, rope, string, etc.

S Avoid heavy contact with solid objects that might stop the tines. If heavy contact occurs, stop the engine and inspect the unit for damage.

SNever operate the cultivator without the tine cover in place and properly secured.

SKeep the tines and guard clear of debris.

SAfter striking a foreign object, stop the engine, disconnect the spark plug and inspect the

cultivator for damage. Repair before restarting.

SDisconnect attachment from the drive engine before cleaning the tines with a hose and water to remove any build--up. Oil the tines to

prevent rust.

S Always wear gloves when servicing or cleaning the tines. The tines become very sharp from use.

S Do not run unit at high speed unless cultivating.

HEDGE TRIMMER SAFETY

DANGER: RISK OF CUT; KEEP HANDS AWAY FROM BLADE -- Blade moves momentarily after the trigger is released. Do not attempt to clear away cut material when the blade is in motion. Make sure the switch is in the OFF position, the spark plug wire is discon- nected, and the blade has stopped moving be-

13

Image 13
Contents Manual de Instrucciones Manuel d’Instructions Boots Hazard Zone Safety RulesUL Classified Product Notice Always useUNIT/MAINTENANCE Safety Operator SafetyFuel Safety Cutting SafetyCarton Contents AssemblyInstalling Brushcutter Attachment Tools RequiredConfiguring Your Unit Assembly of Shoulder StrapTo Relocate Shoulder Strap Clamp Attaching the HandlebarAssembly Information Weed Blade Assembly Information Trimmer HeadAttaching the Plastic Shield and Trimmer Head Attaching the Metal ShieldInstallation of the Metal Blade Operation Switch Throttle Trigger HOW to Start Your UnitStarting a Warm Engine Starting a Flooded EngineOperating the Coupler Installing Optional ATTACH- MentsRemoving Trimmer ATTACH- Ment or Other Optional Attachments Operating PositionCutting Methods Trimmer Line AdvanceTip of the line Does the cutting Work areaOperating Instructions for USE with Weed Blade Additional Safety RulesBLOWER/VACUUM Safety Edger SafetyCultivator Safety Hedge Trimmer SafetySnow Thrower Safety Pole Pruner SafetyMaintenance Blade Replacement Service and AdjustmentsCarburetor Adjustment Replace Spark PlugFuel System Seasonal StorageEngine OtherTroubleshooting Table Cause Remedy Ligations The U.S. Environmental Limited WarrantyIntermediate 125 hours Extended 300 hours