Assembly, Carton Contents, Tools Required

SAFETY NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage in the fingers, hands, and joints of people prone to circulation disorders or abnor- mal swellings. Prolonged use in cold weather has been linked to blood vessel damage in otherwise healthy people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An anti--vibration system does not guarantee the avoidance of these problems. Users who oper- ate power tools on a continual and regular basis must monitor closely their physical condition and the condition of this tool.

SPECIAL NOTICE: This unit is equipped with a temperature limiting muffler and spark ar- resting screen which meets the requirements of California Codes 4442 and 4443. All U.S. forest land and the states of California, Idaho, Maine, Minnesota, New Jersey, Oregon, and Washing- ton require by law that many internal combus- tion engines be equipped with a spark arresting screen. If you operate in a locale where such regulations exist, you are legally responsible for maintaining the operating condition of these parts. Failure to do so is a violation of the law. For normal homeowner use, the muffler and spark arresting screen will not require any ser- vice. After 50 hours of use, we recommend that your muffler be serviced or replaced by your au- thorized service dealer.

ASSEMBLY

CARTON CONTENTS

Check carton contents against the following list:

SPowerhead

SLower attachment (with trimmer head installed)

SCupped washer

1.Loosen the coupler by turning the knob counterclockwise.

Coupler

LOOSEN

S	Large nut for installing blades
S	Hex wrench
S	Handlebar
S	Bracket cover
S	Bracket cover screws (2)
S	Metal blade shield
S	Blade shield screws (4)
S	4--point weed blade
S	Plastic shield

Shipping protector

TIGHTEN

Knob

S	Wing nut (screwed onto plastic shield)
S	Shoulder strap with warning
S	Container of oil

WARNING: Always stop unit and dis- connect spark plug before performing any as- sembly procedures.

WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.

Examine parts for damage. Do not use dam- aged parts.

NOTE: If you need assistance or find parts missing or damaged, call 1-800-554-6723.

It is normal for the fuel filter to rattle in the empty fuel tank.

Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.

TOOLS REQUIRED

SHex wrench (provided) S Adjustable wrench

S Phillips screwdriver

INSTALLING BRUSHCUTTER ATTACHMENT

CAUTION: When installing brushcutter at- tachment, place the unit on a flat surface for stability.

2.Remove shipping protector from coupler.

3.Remove the shaft cap from the brushcutter attachment (if present).

4.Position locking/release button of attach- ment into guide recess of coupler.

5.Push the attachment into the coupler until the locking/release button snaps into the primary hole.

6.Before using the unit, tighten the knob se- curely by turning clockwise.

Coupler	Primary Hole
		Guide Recess
Upper	Locking/	Lower
Upper	Release	Lower
Shaft	Release	Attachment
	Button

WARNING: Make sure the locking/ release button is locked in the primary hole and the knob is securely tightened before op- erating the unit. All attachments are designed to be used in the primary hole unless other- wise stated in the applicable attachment in- struction manual. Using the wrong hole could lead to serious injury or damage to the unit.