STANDARDS: This edger attachment is Listed by Underwriter’s Laboratories, Inc., in ac- cordance with UL Standard 1602,
31cc Powerhead (with trimmer attachment) . . . . . . . . . . . . . . . . . . . . . . . . . . . . PP036 31cc Powerhead (with trimmer attachment) . . . . . . . . . . . . . . . . . . . . . . . . . . . . PP136
ASSEMBLY
WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.
Examine parts for damage. Do not use dam- aged parts.
NOTE: If you need assistance or find parts missing or damaged, call
TOOLS REQUIRED
SHex wrench (provided)
HANDLEBAR ASSEMBLY
DANGER: RISK OF CUT. To avoid serious injury, the barrier portion of the han- dlebar must be installed as shown on the up- per shaft of the powerhead to provide a barrier between operator and the spinning blade. At- tach handlebar mounting bracket above ar- row on safety warning decal on the upper shaft (powerhead end of unit). Ensure han- dlebar is positioned on mounting bracket at the end of the arrow on the handlebar decal. NOTE: Two mounting brackets are included with this attachment. Both brackets are pro- vided to adapt this attachment for use with pow- erheads that have either a 1″ (2.5 cm) diameter or a 7/8″ (2.2 cm) diameter upper shaft. The correct bracket must be used to ensure that the handlebar is mounted securely to the upper shaft before use.
Handlebar 
Screw
Bracket Cover
Mounting 
Bracket
1.Place the mounting bracket over the upper shaft above the arrow on the safety label. Be sure to use the correct mounting brack- et for either the 1″ (2.5 cm) or 7/8″ (2.2 cm) diameter upper shaft.
2.Position one of the bracket covers under the upper shaft and align the mounting bracket and the bracket cover screw holes. Insert two screws into the screw holes.
3.Secure the mounting bracket by tightening the screws with the hex wrench.
4.Locate the decal on the handlebar. This decal includes an arrow. Position the han- dlebar with the mounting bracket at the end of the arrow.
5.Position the second bracket cover over the handlebar. Align the mounting bracket and the bracket cover screw holes. Again make sure the handlebar is at the end of the arrow.
6.Insert two screws and hand tighten only. Be sure the handlebar is installed cor- rectly; then, tighten each screw securely with the hex wrench.
5