Homelite UT20042A, UT20043, UT20003A Starting and Stopping, See Figures 12, To Stop the Engine

Page 15

OPERATION

STARTING AND STOPPING

See Figures 12 and 13.

Trimmer should be on a flat, bare surface for starting.

1.Slowly press the primer bulb seven (7) times.

2.Set the choke lever to the FULL CHOKE position (A).

3.Squeeze the throttle trigger fully and pull starter handle sharply until engine attempts to run. Do not pull the starter handle more than eight (8) times.

NOTE: Keep throttle trigger squeezed fully through STEP 6.

4.Set the choke lever to the HALF CHOKE position (B).

5.Pull the starter handle until the engine runs. Do not pull the starter handle more than six (6) times.

6.Allow the engine to run for 15 seconds, then set the choke lever to the RUN position (C).

TO STOP THE ENGINE:

See Figure 13.

To stop the engine, push and hold the STOP button until the engine stops.

IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT:

Do not return this product to the retail store where it was purchased. Please call our Customer Service Department for any issues you may have.

For Help Call: 1-800-242-4672

Page 15

PRIMER BULB

C

B

A

STOP

STARTING

INSTRUCTION

LABEL

THROTTLE

TRIGGER

Fig. 12

PRIMER BULB

CHOKE LEVER

RUN (C)

C

 

B

 

A

HALF

 

 

CHOKE

ST

(B)

OP

 

 

FULL

 

CHOKE

 

(A)

STOP BUTTON

Fig. 13

Image 15
Contents UT20002, UT20002A UT20003, UT20003A UT20022, UT20022A UT20023, UT20023AUT20042, UT20042A UT20043, UT20043A Introduction Table of ContentsRead ALL Instructions General Safety RulesSpecific Safety Rules for Trimmer USE Specific Safety RulesSymbol Name Explanation SymbolsSymbol Signal Meaning ServiceInstructions SpecificationsWeight without fuel UnpackingTrimlite model UT20002, UT20002A, UT20003, UT20003A FeaturesTrim ‘n Edge model UT20022, UT20022A, UT20023, UT20023A Assembly Front HandleSee Figure See Figures 5 Straight Shaft Grass Deflector Easy ReachFuel Mixture Premium Exact MIX Gasoline OIL Fueling and Refueling the TrimmerOperating the Trimmer Fuel MixtureCutting Tips OperationAdvancing the String CUT OFF BladeSee Figures 10 Edger Guide Operation Trim ‘N Edge onlyIf Assistance is Required for this Product Starting and StoppingSee Figures 12 To Stop the EngineNEW Prewound Spool MaintenanceSpool Replacement EZ Line TAP Advance System To install the spool retainerString Replacement Cleaning the Exhaust Port and MUF- Fler Spark ArrestorSee Figures 16, 17, 18 Spark Plug Replacing and Cleaning AIR FilterSpark Arrestor Cleaning Instructions Fuel CAPTroubleshooting Idle Speed Screw Limited Warranty Statement WarrantyManufacturers Warranty Coverage Emissions Maintenance Schedule and Warranted Parts List California Proposition Service Repair Parts