OPERATION
FILLING TANK
nClean surface around fuel cap to prevent contamination.
nLoosen fuel cap slowly. Rest the cap on a clean surface.
nCarefully pour fuel into the tank. Avoid spillage.
nPrior to replacing the fuel cap, clean and inspect the gasket.
nImmediately replace fuel cap and hand tighten. Wipe up any fuel spillage.
NOTE: It is normal for smoke to be emitted from a new engine after first use.
nSet the choke lever to the HALF CHOKE position (B).
nPull the starter handle until the engine runs. Do not pull the starter handle more than six (6) times.
nAllow the engine to run for 15 seconds, then set the choke lever to the RUN position (C).
TO STOP THE ENGINE:
See Figure 9.
To stop the engine, push and hold the STOP button until the engine stops.
IF ASSISTANCE IS REQUIRED FOR THIS PRODUCT:
WARNING:
Always shut off engine before fueling. Never add fuel to a machine with a running or hot engine. Move at least 30 ft. (9 m) from refueling site before starting engine. Do not smoke!
OPERATING THE TRIMMER
See Figure 8.
WARNING:
Always position the unit on the operator’s right side. The use of the unit on the operator’s left side will expose the user to hot surfaces and can result in possible burn injury.
WARNING:
To avoid burns from hot surfaces, never operate unit with the bottom of the engine above waist level.
Hold the trimmer with your right hand on the rear handle and your left hand on the front handle. Keep a firm grip with both hands while in operation. Trimmer should be held at a com- fortable position with the rear handle about hip height.
Always operate trimmer at full throttle. Cut tall grass from the top down. This will prevent grass from wrapping around the shaft housing and string head which may cause damage from overheating. If grass becomes wrapped around the string head, STOP THE ENGINE, disconnect the spark plug wire, and remove the grass. Prolonged cutting at partial throttle will result in oil dripping from the muffler.
STARTING AND STOPPING
See Figures 8 - 9.
Trimmer should be on a flat, bare surface for starting.
nSlowly press the primer bulb seven (7) times.
nSet the choke lever to the FULL CHOKE position (A).
nSqueeze the throttle trigger fully and pull starter handle sharply until engine attempts to run. Do not pull the starter handle more than eight (8) times.
NOTE: Keep throttle trigger squeezed fully.
Do not return this product to the retail store where it was purchased. Please call our Customer Service Department for any issues you may have.
For Help Call: 1-800-242-4672
PRIMER
BULB
C 
B 
A
STOP
STARTING
INSTRUCTION
LABEL
| THROTTLE |
| |
| TRIGGER | Fig. 8 | |
|
|
| |
|
| PRIMER BULB | |
CHOKE LEVER |
|
| RUN (C) |
|
|
| |
| C |
|
|
| B |
|
|
| A |
| HALF |
|
|
| |
|
|
| CHOKE (B) |
| ST |
|
|
| OP |
|
|
|
|
| FULL |
|
|
| CHOKE (A) |
|
| STOP BUTTON | |
|
|
| Fig. 9 |
Page 11