ASSEMBLY
UNPACKING
This product requires assembly.
nCarefully remove the tool and any accessories from the box. Make sure that all items listed in the packing list are included.
nInspect the tool carefully to make sure no breakage or damage occurred during shipping.
nDo not discard the packing material until you have care- fully inspected and satisfactorily operated the tool.
nIf any parts are damaged or missing, please call
PACKING LIST
Trimmer Assembly Operator’s Kit Front Handle
Curved Shaft Grass Deflector - Trim ‘n Edge and Trimlite Straight Shaft Grass Deflector - Easy Reach
Edger Guide - Trim ‘n Edge
Hardware Bags (2) - Trimlite and Easy Reach Hardware Bags (3) - Trim ‘n Edge
Bottle of
Operator’s Manual
WARNING:
If any parts are missing do not operate this tool until the missing parts are replaced. Failure to do so could result in possible serious personal injury.
WARNING:
Do not attempt to modify this tool or create accesso- ries not recommended for use with this tool. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause serious personal injury, always disconnect the engine spark plug wire from the spark plug when assembling parts.
FRONT HANDLE
See Figure 2.
nRemove the front handle, bolt, and wing nut from the operator’s kit.
nInstall the front handle onto the top side of the drive shaft housing and move it to a comfortable position.
nPlace the bolt through the front handle as shown, then install the wing nut.
nTighten wing nut securely.
CURVED SHAFT GRASS DEFLECTOR WITH- OUT EDGER GUIDE - TRIMLITE AND TRIM ‘N EDGE
See Figure 3.
nRemove wing nut, flat washer, lock washer, and bolt from the operator’s kit.
nPlace curved shaft grass deflector over shaft and bracket.
nInstall bolt through the slots in the tabs on grass deflector and bracket on shaft housing.
nInstall flat washer, lock washer, and wing nut.
nTighten securely.
FRONT
HANDLE
WING
NUT 
BOLT
| Fig. 2 |
BOLT | GRASS |
| DEFLECTOR |
BRACKET
| LOCK |
| WASHER |
FLAT | WING NUT |
WASHER |
Fig. 3
Page 8