Homelite UT20811E Starting and Stopping, See, To Start a Cold Engine, To Start a Warm Engine

OPERATION

STARTING AND STOPPING

See Figure 8 and 9.

TO START A COLD ENGINE:

1.Lay the trimmer on a flat, bare surface.

2.Make sure the switch is in the run “I” position.

2.Push the primer bulb 8 to 10 times.

3.Set the choke lever to the choke position .

4.Squeeze the throttle trigger to the full throttle position.

5.Pull the starter until the engine tries to run. No more than 6 pulls.

6.Set the choke lever to the half choke position .

7.Hold the trigger and the pull starter rope until the engine runs.

8.Run the engine 30 to 45 seconds at full throttle (with the

trigger depressed fully) on half choke position to warm up the engine. Move the choke lever to the run position .

TO START A WARM ENGINE:

1.Move the choke lever to the run position .

2.Hold the trigger and pull the starter rope until the engine runs.

TO STOP THE ENGINE:

To stop the engine, press and hold the switch in the STOP position “O”.

IGNITION SWITCH

I= ON TO RUN O = OFF TO STOP

THROTTLE INTERLOCK

THROTTLE

TRIGGER

Fig. 8

PRIMER BULB

CHOKE LEVER

RUN POSITION

3
2
1	HALF
	CHOKE
	POSITION
	CHOKE
	POSITION
	Fig. 9

Page 10