SAFETY INSTRUCTIONS
Throttle lock-out
SMake sure the throttle control is locked at the idle setting when the throttle
SPress the throttle
SCheck that the throttle control and throttle
return springs work properly.
SSee instructions under the section “Start”. Start the machine and apply full throttle. Release the throttle and check that the cutting attachment stops and re- mains at a standstill. If the cutting attach- ment rotates with the throttle in the idle position then the carburetor idle setting must be checked. See instructions under the section “Maintenance”.
115275126 Rev. 1 9/15/09
Stop switch
SStart the engine and make sure the engine stops when you push and hold the stop switch.
Cutting attachment guard
SEnsure that the guard is undamaged and is not cracked.
SReplace the guard if it has been exposed
to impact or is cracked.
SAlways use the recommended guard for the cutting attachment you are using. See section on “Technical data”.
Muffler
SNever use a machine that has a faulty muffler.
SRegularly check that the muffler is securely attached to the machine.
SThe muffler on this unit is equipped with a special spark arrestor mesh. The mesh should be checked and, if necessary. cleaned by a servicing dealer. A blocked mesh will cause the machine to overheat, which can lead to serious damage. Never use a muffler with a defective spark arres- tor mesh. See the Maintenance section.