Husqvarna Two-piece shaft 327LDx, Air filter, Cleaning the air filter, Oiling the air filter

Page 21

MAINTENANCE

If the machine is low on power, difficult to start or runs poorly at idle speed: always check the spark plug first before taking any further action. If the spark plug is dirty, clean it and check that the electrode gap is 0.020 inch (0.5 mm). The spark plug should be replaced after about a month in operation or earlier if necessary.

CAUTION! Always use the recommended spark plug type! Use of the wrong spark plug can damage the piston/ cylinder. Check that the spark plug is fitted with a suppressor.

Two-piece shaft (327LDx)

The drive shaft end in the lower shaft should be lubricated with grease every 30 hours. There is a risk that the drive shaft ends (splined coupling) on models with two-piece shafts will seize if they are not lubricated regularly.

Air filter

The air filter must be regularly cleaned to remove dust and dirt in order to avoid:

Carburettor malfunctions

Starting problems

Loss of engine power

Unnecessary wear to engine parts

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if conditions are exceptionally dusty.

Cleaning the air filter

Remove the air filter cover and take out the filter. Wash it clean in warm, soapy water. Ensure that the filter is dry before refitting it.

An air filter that has been in use for a long time cannot be cleaned completely. The filter must therefore be replaced with a new one at regular intervals. A damaged air filter

must always be replaced.

If the machine is used in dusty conditions the air filter should be soaked in oil. See instructions under the heading Oiling the air filter.

Oiling the air filter

Always use HUSQVARNA filter oil, art. no. 531 00 92-48. The filter oil contains a solvent to make it spread evenly through the filter. You should therefore avoid skin contact.

Put the filter in a plastic bag and pour the filter oil over it. Knead the plastic bag to distribute the oil. Squeeze the excess oil out of the filter inside the plastic bag and pour off the excess before fitting the filter to the machine. Never use common engine oil. This would drain through the filter quite quickly and collect in the bottom.

English 21

Image 21
Contents 327LS 327LDX-series Symbols KEY to SymbolsContents Dear customer IntroductionWhat is what? What is WHAT?Personal protective equipment General Safety PrecautionsThrottle lockout Machine′s safety equipmentCutting attachment guard Stop switchVibration damping system MufflerCutting equipment Trimmer head Assembly AssemblyFitting the loop handle Assembling and dismantling the two-piece shaft 327LDxFitting the trimmer guard and trimmer head Assembling the cutting equipmentFuel safety Fuel HandlingFuel Mixing FuelingCheck before starting Starting and StoppingStarting and stopping StartingStopping Basic safety rules Working TechniquesGeneral working instructions Grass trimming with a trimmer head Basic working techniquesMaintenance CarburetorMuffler Cooling system Spark plugRemember the risk of fire Two-piece shaft 327LDx Cleaning the air filterAir filter Oiling the air filterBevel gear Maintenance Daily Weekly Monthly Maintenance scheduleTechnical data Technical Data327LDx Powerhead model Accessories Art NoYour Warranty Rights and Obligations Emission Warranty Parts List Page S35 2,7mm 095-.106 25 m 15 cm T35, T35x T25 Page Page Page Original instructions 1153293-95