Dismantling takes place in the reverse order

ASSEMBLY

Assembling the blade guard and grass blade

Assembling other guards and cutting equipment

•The guard (A) is fitted using 4 screws (L) and the support plate (M) as set out in the diagram. NOTE! Use the recommended blade guard.

•Fit the drive disc (B) on the output axle.

•Turn the blade axle until one of the holes in the drive disc aligns with the hole in the gear housing.

•Insert the locking pin (C) in the hole so that the axle is locked.

•Place the blade (D), support cup (E) and support flange (F) on the output axle.

•Fit the nut (G). The tightening torque of the nut is 35-50 Nm (3,5 - 5 kpm). Use the socket spanner in the tool kit. Hold the handle of the spanner as close to the blade guard as possible. The nut is tightened when the spanner is turned against the direction of rotation (left-hand thread).

	G
	F
	E
	D
A	B
	B
	C
L
	M

•Fit the guard (A) intended for use with the trimmer head. Secure using four bolts

(L)and the support plate

(M)as shown in the diagram.

•Fit the disc drive (B) on the output axle.

•Turn the blade axle until one of the disc drive’s holes aligns with the corresponding hole in the gear housing.

•Insert the locking pin

(C)into the hole to lock the axle.

•Screw on the trimmer head (H) in the direction of rotation.

•Dismantling takes place in the reverse order.

A	L	B
	L

		C
M
	H

English – 15