Husqvarna 225E manual Assembly, Assembling the blade, Assembling the angle gear

	ASSEMBLY
Assembling the loop handlebar	Assembling the blade
• Unscrew the handle and	Fit the blade as follows:
plastic cover from the	1. Fit the drive disc (A) on the
handlebar bracket.
		outgoing shaft. Make sure
		that the edge that fits in
		the hole of the blade is
• Place the loop handlebar with		facing outward.
the handlebar holder on the	2.	Block the blade rotation by
handlebar bracket. Fit the
		inserting locking pin in the
handle and plastic cover. Do
		hole behind the blade
not tighten too tight.
		guard engaging it in the
		corresponding hole in the
		drive disc.
	3. Fit the blade (B) on the
		drive disc.
	4.	Fit the support	A
			B
		flange (C). The support	C
		flange must be fitted with	D
		its outer edge hard up
		against the blade.
	5. Fit the locknut (D). NOTE!
		The locknut has left-hand
		threads. The tightening
		torque of the locknut is 35
		– 50 Nm.
	6.	Remove the locking pin.
Assembling the angle gear

• Assemble the angle gear	NOTE! Do not forget to remove the locking pin before using
back on the supporting tube.
Turn the blade so that the	the machine.
drive shaft engages in the
angle gear.	!
		WARNING!
		Under no circumstances may the edge cutter
• Position the angle gear so		blade be used without the blade guard fitted.
that its slot is aligned with the
line on the supporting tube.

• Firmly tighten the screw.

English – 13