Husqvarna 225E manual Start and Stop, Control before starting, Start and stop

Page 15

START AND STOP

Control before starting

For reasons of safety follow these recommendations!

Check that the support flange is not cracked due to fatigue

or due to being tightened too much. Replace the support flange if it is cracked.

• Ensure that the nut has not lost its tightening capacity The nut lock shall have a locking torque of at least 1.5Nm. The nut‘s tightening torque shall be 35-50 Nm.

Check that the blade and the blade guard are not damaged

or cracked. Replace the blade or blade guard if it has been exposed to impact or if it is cracked.

Cold engine

IGNITION:

Set the stop switch to the start position.

CHOKE:

Set the choke control in the choke position.

Warm engine

Use the same starting proce- dure as for the cold engine, but do not set the choke control in the choke position. The start throttle position is obtained by setting the choke control in the choke position and then returning it to its original position.

Stop

The engine is stopped by switching off the ignition.

!WARNING!

When the engine starts with the choke lever in the choke or starter throttle position the cutting tool (blade or trimmer) starts to rotate immediately.

Start and stop

!WARNING!

The complete clutch cover with shaft must be fitted before the machine is started, otherwise the clutch can become loose and cause personal injury.

Always move the machine from the filling position before starting. Place the machine on a flat surface. Make sure the blade cannot come into contact with any object. Make sure that no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury. The safety distance is 15 metres.

Start

Press the machine body against the ground using your left hand (NOTE! Do not use your foot). Grip the starter handle with your right hand and slowly pull the starter cord out until you feel some resis- tance, (the starter hooks grip) then pull the cord quickly and powerfully .

Immediately press the choke control in when the engine fires and repeat until the engine starts. When the engine starts, quickly apply full throttle and the start throttle will automati- cally disengage.

NOTE! Do not pull the starter cord out completely and do not release the starter cord from the fully extended position. This can damage the machine.

English – 15

Image 15
Contents 101 89 225ESymbols Symbol ExplanationContents Safety Instructions Machine‘s safety equipmentPersonal protective equipment Locking nut Vibration damping systemMuffler Cutting equipmentSafety Instructions Safety Instructions Personal protection General safety instructionsSafety instructions regarding the surroundings Safety instructions before starting workFuel safety StartTransport and storage Safety instruction while working Basic safety precautionsGeneral working instructions Basic working techniques Safety instructions after completing work What is what on the edger? What is WHAT?Assembly Assembling the bladeAssembling the angle gear Fuel Handling Fuel mixtureFuelling Start and Stop Control before startingStart and stop Carburetor MaintenanceHigh speed needle H Correctly adjusted carburetor Final setting of the idling speed TCleaning the air filter Muffler with catalytic converter Cooling systemAir filter Spark plug Lubricating the flexible drive axle Adjusting the edger‘s cutting depth Angle gearMonthly maintenance Maintenance scheduleDaily maintenance Weekly maintenanceTechnical Data Technical data225E «*2¥5$¬ English «*2¥5$¬