Troy-Bilt 52052, 52051 owner manual Do not, Watch for traffic when near or when crossing roadways

Page 4

Section 1: Safety

20.Always wear approved safety gog- gles or safety glasses with side shields when operating equipment. The use of any powered machine can result in for- eign objects being thrown by high- speed rotating parts which can cause personal injury or property damage. Stay away from glass and other easily thrown or breakable objects.

21.Wear work gloves and sturdy footwear when using this equipment. Leather work shoes or short boots are ideal. They protect ankles and shins from rocks, pebbles, splinters, etc.

22.It is advisable to wear protective headgear to prevent the possibility of being hit by small flying particles, etc.

23.Before each use, inspect the throt- tle control lever and cable (if so equipped). Make sure the cable is free and the lever functions properly.

24.Watch for traffic when near or when crossing roadways.

25.Never attempt to carry children or other passengers on the equipment. They could fall off and be seriously in- jured, or they could interfere with safe operation of the equipment.

26.The mower is equipped with a plastic debris shield in front of the en- gine and a rubber debris flap under the frame. They must be in place and working properly. Never remove or cause the debris shield or debris flap to cease working. If either of these parts is missing or not working properly, do not use the equipment until this situa- tion is corrected.

27.Be aware of where the trimmer/ mower is discharging materials and do not point the discharge at anyone.

28.Never run the engine in an en- closed area. Engine exhaust contains carbon monoxide, a deadly gas that is odorless, colorless and tasteless. Always run the engine outdoors where there is adequate ventilation.

29.Slow down before turning.

30.Shut off engine when not trimming or mowing.

31.Use extra care when loading or un- loading machine into a trailer or truck.

32.Use this equipment for its intended purpose only.

33.Always make sure the handlebars are tight and comfortably positioned.

They should never be in an awkward position for the operator.

II. Slope Operation

Slopes are a major factor related to loss of control and tip-over accidents which can result in severe injury or death. All slopes require extra cau- tion. If you can not back up the slope or you feel uneasy on a slope, do not mow it.

DO:

Mow across the face of slopes; never up and down. Exercise extreme cau- tion when changing direction on

slopes. Avoid slopes greater than 15o.

Remove objects such as rocks, tree limbs, etc.

Uneven terrain could overturn the machine. Watch for holes, ruts, or bumps. Tall grass can hide obstacles.

Use slow speed.

Use extra care with grass catchers or other attachments. These can change the stability of the machine. Keep all movement on the slopes slow and gradual.

Avoid starting or stopping on a slope.

M

IS

DO NOT:

Do not mow near drop-offs, ditches, or embankments. You could lose footing or balance.

Do not mow on very steep slopes.

Do not mow on wet grass. Slippery footing can be hazardous.

III. Children

Tragic accidents can occur if the op- erator is not alert to the presence of children. Children are often attracted to the trimmer/ mower and the mow- ing activity. Never assume that chil- dren will remain where you last saw them.

1.Keep children out of the mowing area and under the watchful care of a responsible adult.

2.Be alert and turn trimmer/mower off if children enter the area.

3.Before and while moving back- wards, look behind and down for small children.

4.Never allow children to operate the mower.

5.Use extra care near blind corners, shrubs, trees, or other objects that may obscure vision.

6.Never carry children, even with the trimmer head stopped. Children may fall off and be seriously in- jured or interfere with safe ma- chine operation.

7.Do not allow children nearby if you are working.

IV. Service

1.Use extra care in handling gaso- line and other fuels. They are flammable and their vapors are ex- plosive. To help prevent a fire or explosion:

a)Use only an approved con- tainer.

b)Never remove gas cap or add fuel when the engine is run- ning. Let engine cool before re- fueling. Do not smoke.

c)Never refuel the machine in- doors. Fill the fuel tank out- doors and with extreme care.

d)Never store the machine or fuel container inside where there is an open flame, such as a water heater, etc.

e)Replace caps on the fuel tank and fuel container and clean up spilled fuel before starting engine. Move machine away from any gasoline fumes be- fore starting the engine.

f)Keep matches, smoking ma- terials, open flames, and sparks away from the fuel tank and fuel container.

g)Leave 1/2" air space at the top of the fuel tank to allow for fuel expansion.

2

Image 4
Contents Trimmer/Mower Recoil Start Model ShownSee Back Cover for Customer Service Information Do not put SafetyRemove the key on electric start models Do not Watch for traffic when near or when crossing roadwaysUse this equipment for its intended purpose only Never make adjustments or repairs while engine is running At rear of deck Housing on left sideNever run the engine inside a closed area At top of debris shield braceAssembly IntroductionAdd Motor Oil Features and Controls Engine CONTROLS/FEATURESUse this lever F, -1 to regulate engine speed Recoil starter H, -1 is mounted on the enginePRE-START Checklist Adjust Handlebar HeightOperation IntroductionUsing the Trimmer Head Control Bail Adjust Line Cutting HeightTough trimming conditions, use the highest height settings General RecommendationsElectric Start Model Recoil Start ModelMer/mower Vary the Throttle Setting to Suit the Job Trimming & Mowing Techniques and TipsUse the Right Diameter Line for the Trimming Job Be alert to hidden obstaclesRequired Maintenance Schedule Maintenance/Repairs100 Removing & Replacing the Trimmer Head Adjusting Trimmer Head EngagementSecurely Inspecting / Replacing the Drive Belt Belt ReplacementBelt Inspection Belt Performance Troubleshooting Cleaning and Debris RemovalChanging Trimmer Mower Lines To Change Trimmer LinesRepeat steps 2 through 5 to replace the second trimmer line DirectionCleaning the Engine Foam Debris Filter General Engine MaintenanceGeneral Lubrication Compact StorageBattery Recharging Battery ReplacementProblem Possible Cause Correction Engine does not startParts Ordering Information Trimmer/Mower Parts List Ref. # Description Ref. # Description QtyHandlebar Assembly Spindle Plate Assembly Lower Steering Assembly Trim Head Assembly Description QtyWarranty Service Customer Service and Technical ServiceReplacement Parts Engine Service and Repair

52051, 52052 specifications

Troy-Bilt has long been recognized for its commitment to quality and innovation in outdoor power equipment, and the Troy-Bilt 52052 and 52051 models are no exception. These garden tillers are designed to tackle a variety of tilling tasks, making them suitable for both novice gardeners and seasoned horticulturists.

The Troy-Bilt 52052 features a robust 4-cycle engine, which provides ample power to tackle tough soil conditions. With a displacement of 196 cc, this model is equipped to till soil up to 10 inches deep, ensuring that nutrients can be effectively mixed into your garden bed. The 52051 shares similar characteristics but is tailored for slightly different gardening needs. Both models feature an adjustable tilling width, allowing users to customize their tilling experience, with widths ranging from 16 to 21 inches. This versatility enables gardeners to efficiently navigate tight spaces or cover larger plots in fewer passes.

One of the standout technologies integrated into these models is the "Rear-Tine" design, which allows for smoother operation and superior maneuverability. This design feature not only enhances ease of use but also reduces strain on the user, making gardening tasks less daunting. The counter-rotating tines of the tillers are specifically designed to break up hard soil, allowing for effective aeration and preparation of planting beds.

Both models excel in terms of convenience, featuring a user-friendly starting system. The push-button electric start on the 52052 is particularly beneficial for those who may have difficulty with traditional pull-start mechanisms. Additionally, the tillers are designed with ergonomic controls, ensuring that users can operate them comfortably for extended periods.

Durability is another hallmark of the Troy-Bilt brand, and these tillers are constructed with high-quality materials to withstand the rigors of regular use. The heavy-duty steel tines are built to last, and the sturdy frame ensures stability while in operation.

In summary, the Troy-Bilt 52052 and 52051 garden tillers combine power, versatility, and user-friendly features, making them excellent choices for anyone looking to enhance their gardening experience. With their advanced technologies and robust construction, these tillers promise to deliver outstanding performance for all your gardening needs.