Troy-Bilt 52051, 52052 owner manual Operation, Introduction, PRE-START Checklist, Fill Fuel Tank

Page 9

Section

4 Operation

WARNING

Before operating your ma- chine, carefully read and un- derstand all safety (Section 1), controls (Section 3) and

operating instructions (Section 4) in this Manual, in the separate Engine Owner’s Manual, and on the decals on the machine.

Failure to follow these in- structions can result in seri- ous personal injury.

INTRODUCTION

As with any piece of outdoor power equipment, getting the “feel” for how your machine operates and knowing the best techniques for particular jobs are important to overall good performance.

Read this Section thoroughly before you start the engine. The instructions given here will help you become familiar with your machine and have you operating it efficiently in a short time.

NOTE: All references to left, right, front and rear of the machine are determined by standing in the operator’s position.

PRE-START CHECKLIST

A.Review Section 1: Safety and also Section 3: Features and Controls.

B.Check equipment for loose or miss- ing hardware. Tighten or replace hard- ware before starting trimmer/mower.

C.Check the engine oil level*. It must be up to the “FULL” mark on the oil dipstick. (See the Engine Owner’s Manual for instructions.)

D.Check the fuel level* in the fuel tank. (See the Engine Owner’s Manual and this page for instructions.)

E.Check the trimmer head control bail for freedom of movement.

F.Check engine throttle control lever (on units so equipped) for freedom of movement.

G.Select the cutting height (see this Section for full details).

H.Check handlebar height position.

I.On electric start models, check the wire harness connections.

J.Carefully check the area to be trimmed and remove any debris.

K. Check that the spark plug wire is securely attached to the spark plug.

*Clean debris from around fuel cap, oil dipstick, and engine foam debris fil- ter before checking oil level or adding gasoline, in order to keep dirt out of engine.

FILL FUEL TANK

A.Lift and tilt plastic debris shield for- ward (refer to Figure 3-1).

B.Clean fuel fill area and debris filter each time before fuel is added.

C.Unscrew fuel tank cap and insert a clean funnel into fuel tank (or use a fuel container with a flexible spout). See Engine Owner’s Manual for the correct gasoline specifications. Slowly fill the fuel tank, leaving at least 1/2-inch of air space at the top for fuel expansion.

D.Securely replace the fuel tank cap and the fuel container cap. Promptly wipe up any fuel spills.

E.Lift and tilt the debris shield back, then push it down to secure it.

ADJUST HANDLEBAR HEIGHT

To adjust handlebar height, refer to “STEP 2: Install Handlebars” in the Assembly Section of this manual.

DANGER

Gasoline is highly flammable and its vapors are explosive.

Never fill fuel tank when engine is running or still hot from operation. Allow the engine to cool at least two minutes before refueling.

Do not allow open flames, sparks, matches or smoking in the area.

Fill the fuel tank outdoors in a well-ventilated area.

Wipe up any spills and move the trimmer/mower away from gasoline fumes before starting the engine.

Securely replace the caps on fuel tank and fuel container.

Use only an approved fuel container. Store it safely, out of the reach of children.

Store gasoline in a well ventilated area. Do not store it where vapors could reach an open flame, spark, or ig- nition sources (such as hot water heater or space heater, furnace, clothes dryer, stove, electric motor, etc.).

Failure to follow these in- structions can cause personal injury or property damage.

CAUTION

Before adjusting the handle- bar height, shut off the en- gine, wait for all moving parts to stop, allow the en- gine to cool, disconnect the spark plug wire and prevent it from touching the spark plug.

Failure to comply could result in personal injury or property damage.

7

Image 9
Contents Recoil Start Model Shown Trimmer/MowerSee Back Cover for Customer Service Information Safety Do not putRemove the key on electric start models Watch for traffic when near or when crossing roadways Do notUse this equipment for its intended purpose only At rear of deck Housing on left side Never make adjustments or repairs while engine is runningNever run the engine inside a closed area At top of debris shield braceIntroduction AssemblyAdd Motor Oil Engine CONTROLS/FEATURES Features and ControlsUse this lever F, -1 to regulate engine speed Recoil starter H, -1 is mounted on the engineAdjust Handlebar Height PRE-START ChecklistOperation IntroductionAdjust Line Cutting Height Using the Trimmer Head Control BailTough trimming conditions, use the highest height settings General RecommendationsRecoil Start Model Electric Start ModelMer/mower Trimming & Mowing Techniques and Tips Vary the Throttle Setting to Suit the JobUse the Right Diameter Line for the Trimming Job Be alert to hidden obstaclesMaintenance/Repairs Required Maintenance Schedule100 Adjusting Trimmer Head Engagement Removing & Replacing the Trimmer HeadSecurely Belt Replacement Inspecting / Replacing the Drive BeltBelt Inspection Cleaning and Debris Removal Belt Performance TroubleshootingTo Change Trimmer Lines Changing Trimmer Mower LinesRepeat steps 2 through 5 to replace the second trimmer line DirectionGeneral Engine Maintenance Cleaning the Engine Foam Debris FilterGeneral Lubrication Compact StorageBattery Replacement Battery RechargingEngine does not start Problem Possible Cause CorrectionParts Ordering Information Trimmer/Mower Parts List Ref. # Description Qty Ref. # DescriptionHandlebar Assembly Spindle Plate Assembly Lower Steering Assembly Description Qty Trim Head AssemblyCustomer Service and Technical Service Warranty ServiceReplacement Parts Engine Service and Repair

52051, 52052 specifications

Troy-Bilt has long been recognized for its commitment to quality and innovation in outdoor power equipment, and the Troy-Bilt 52052 and 52051 models are no exception. These garden tillers are designed to tackle a variety of tilling tasks, making them suitable for both novice gardeners and seasoned horticulturists.

The Troy-Bilt 52052 features a robust 4-cycle engine, which provides ample power to tackle tough soil conditions. With a displacement of 196 cc, this model is equipped to till soil up to 10 inches deep, ensuring that nutrients can be effectively mixed into your garden bed. The 52051 shares similar characteristics but is tailored for slightly different gardening needs. Both models feature an adjustable tilling width, allowing users to customize their tilling experience, with widths ranging from 16 to 21 inches. This versatility enables gardeners to efficiently navigate tight spaces or cover larger plots in fewer passes.

One of the standout technologies integrated into these models is the "Rear-Tine" design, which allows for smoother operation and superior maneuverability. This design feature not only enhances ease of use but also reduces strain on the user, making gardening tasks less daunting. The counter-rotating tines of the tillers are specifically designed to break up hard soil, allowing for effective aeration and preparation of planting beds.

Both models excel in terms of convenience, featuring a user-friendly starting system. The push-button electric start on the 52052 is particularly beneficial for those who may have difficulty with traditional pull-start mechanisms. Additionally, the tillers are designed with ergonomic controls, ensuring that users can operate them comfortably for extended periods.

Durability is another hallmark of the Troy-Bilt brand, and these tillers are constructed with high-quality materials to withstand the rigors of regular use. The heavy-duty steel tines are built to last, and the sturdy frame ensures stability while in operation.

In summary, the Troy-Bilt 52052 and 52051 garden tillers combine power, versatility, and user-friendly features, making them excellent choices for anyone looking to enhance their gardening experience. With their advanced technologies and robust construction, these tillers promise to deliver outstanding performance for all your gardening needs.