Ryobi HT816r, HT818r, HT822r manual Blade Cover Screw

Page 11

MAINTENANCE AND REPAIR INSTRUCTIONS

Blade Cover

Screw

Fig. 12

Fig. 13

8.Replace blade screws. Tighten screws securely.

9.Replace blade cover screw (Fig. 14).

NOTE: Do not tighten blade cover screw until blade cover has been replaced.

10.Replace blade cover. Place rear tab inside housing, align front tabs with slots in housing, then slide blade cover back into its correct position (Fig. 15).

11.Tighten blade cover screw securely.

Fig. 14

Fig. 15

WARNING: Make sure blade cover is replaced before connecting your hedge trimmer to power supply. Failure to do so will expose internal parts which could cause an accident or electrical shock resulting in serious injury.

NOTE: If binding occurs after replacing blade assembly, repeat the steps above for reassembly.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents OPERATOR’S Manual Introduction Table of ContentsRules for Safe Operation Safety Alert SymbolFor Safe Operation Before OperatingFor Service INFORMATION, Call Other Safety WarningsSafety and International Symbols Symbolmeaning Safety Alert SymbolApplication Assembly InstructionsInstalling Front Handle Extension Cord Retainer LOCK-ON FeatureOperating Instructions To Turn Your Hedge Trimmer onGeneral Tips Using the Hedge TrimmerTo Trim a Hedge Maintenance and Repair Instructions Blade Replacement Blade Cover Screw Inspect Extension Cords SpecificationsCleaning the Unit Servicing of Double Insulated UnitsDescription Replacement Parts12/99 REV. a
Top Page Image Contents