RULES FOR SAFE OPERATION
KNOW YOUR UNIT | |
|
|
APPLICATION
This unit is intended for household purpose only. Use the Hedge Trimmer for;
• Trimming and the forming of hedges, shrubs, and bushes with a branch diameter of up to 3/8 inch.
Blade Guard
Front Handle
Switch Trigger
Rear Handle
Extension Cord
Retainer
Cutting Blade
ASSEMBLY INSTRUCTIONS
INSTALLING FRONT HANDLE
After removing your hedge trimmer from its carton, remove the front handle, screw, and lock nut from the plastic bag. Using a flat blade screwdriver, which is the only tool needed for assembly, install as follows:
WARNING: To prevent serious personal injury, the handle must be installed when operating this unit.
1.Turn the front handle so that the flat surface faces the blade guard of your trimmer.
Front Handle | Blade Guard |
| |
Rear Handle |
|
Screw | Handle Slot |
| |
Ears | Lock Nut |
| Fig. 1 |
NOTE: The hollow side of the front handle faces the rear handle when installed properly.
2.Spread the ears of the front handle and fit into the handle slots on the motor housing (Fig. 1).
NOTE: For your convenience and ease of assembly one of the ears on the front handle has been keyed.
3.Place your trimmer on a workbench and place lock nut into molded slot on right side of the front handle.
4.Insert screw from left to right through the front handle and motor housing (Fig. 2).
5.Tighten screw and lock nut securely with a flat blade screwdriver.
Screw
Lock Nut
Fig. 2
6