GE 10 AZA Through-the-wallinstallation, Instructions Safety Instructions, Inside, Outside

Instructions Safety Instructions

Through-the-wall installation.

Read these instructions completely and carefully.

1	Preparation of the Opening in the Wall
	Make certain a wall receptacle is available close to
	the hole location or make arrangements to install

a receptacle.

The cord length for the 115-volt models is 72″ to the right and 47″ to the left.

For the 230/208-volt models the cord length is 65″ to the right and 39″ to the left.

Installation Instructions Care and Cleaning Operating

2

Support Requirements for the Air Conditioner

The air conditioner wall case may be installed flush with the inside wall or flush with the outside wall.

The finished sides of the opening should be structural wall members.

Lintel—Use a lintel in brick veneer and brick and block types of wall to support the bricks or blocks above the opening. Do not allow the wall case to be used in lieu of a lintel.

Flashing—Install flashing (drip rail) as shown to prevent water from dripping inside the wall and down the outside of the building.

Brick veneer
Lintel angle
(if required)		Plaster
Caulking		line
(on all 4 sides
on the outside		Trim
of the case)
		molding
		(if desired)
		Room side
	Caulking
	(above &
	below the
	flashing)
Flashing
(drip rail)

1/4″ min. extension inside the wall from

the trim molding

Consumer Support Troubleshooting Tips

3

Support Requirements for the Air Conditioner

Mortar between the case and the brick all around the case may be undercut at about 45° for improved caulking.

	Inside
	Top of case
	Outside
Caulking	Undercut
	mortar

22